Lake Shore Model 332 Temperature Controller User’s Manual
Specifications (Continued)
Accessories Included
Part Number
Description
106-009
Heater output connector (dual banana jack)
G-106-233
Sensor input mating connector (6-pin DIN plugs); 2 included
106-234
Terminal block, 8-pin
MAN-332 User
manual
CalCurve™ Options
8001-332
CalCurve, factory-installed, consists of a calibrated sensor breakpoint table factory-
installed into non-volatile memory
8002-05-332
CalCurve, field-installed, consists of a calibrated sensor breakpoint table loaded into
non-volatile memory
Accessories Available
4005
1 meter (3.3 feet) long IEEE-488 (GPIB) computer interface cable assembly. Includes
extender required for simultaneous use of IEEE cable and relay terminal block
RM-1/2
Rack mount kit for one ½ rack temperature controller in a 483 mm (19 inch) rack,
90 mm (3.5 inches) high
RM-2
Rack mount kit for two ½ rack temperature controllers in a 483 mm (19 inch) rack,
135 mm (5.3 inches) high
Refer to Chapter 7 of this manual for a complete description of Model 332 options and accessories.
Specifications are subject to change without notice.
1.4 SAFETY
SUMMARY
Observe these general safety precautions during all phases of instrument operation, service, and
repair. Failure to comply with these precautions or with specific warnings elsewhere in this manual
violates safety standards of design, manufacture, and intended instrument use. Lake Shore
Cryotronics, Inc. assumes no liability for Customer failure to comply with these requirements.
The Model 332 protects the operator and surrounding area from electric shock or burn, mechanical
hazards, excessive temperature, and spread of fire from the instrument. Environmental conditions
outside of the conditions below may pose a hazard to the operator and surrounding area.
• Indoor use.
• Altitude to 2000 meters.
• Temperature for safe operation: 5 °C to 40 °C.
• Maximum relative humidity: 80% for temperature up to 31 °C decreasing linearly to 50% at 40 °C.
• Power supply voltage fluctuations not to exceed ±10% of the nominal voltage.
• Overvoltage category II.
• Pollution degree 2.
Ground The Instrument
To minimize shock hazard, the instrument is equipped with a three-conductor AC power cable.
Plug the power cable into an approved three-contact electrical outlet or use a three-contact adapter
with the grounding wire (green) firmly connected to an electrical ground (safety ground) at the power
outlet. The power jack and mating plug of the power cable meet Underwriters Laboratories (UL) and
International Electrotechnical Commission (IEC) safety standards.
Introduction
1-11
