EN
PRODUCT INFORMATION AND INSTRUCTIONS
Thank you for purchasing a Lamart brand product by Piere Lamart
■
FEATURES
1. Indicate volume of water and milk
2. Two weight unit systems g
ˎ
lb:oz convertible
3. Two volume unit systems ml
ˎ
fl ’oz convertible
4. Low battery power / Overload indication
5. With high precision strain gauge sensor
6. With zero, tare function
7. Auto off
■
TO INSTALL OR REPLACE BATTERY
The battery type of scale depends on the product structure. Find the battery type of your scale according to the following pictures, then install and replace battery as described.
1. 1×3V CR2032 lithium battery (included). Remove isolation sheet before use.
2. 2×1,5V (AA/AAA) batteries (excluded). Remove package foil before use.
PIC 1
Battery baffl e
Open the battery case cover at the bottom of scale:
A. Take out the used battery with the aid of a sharp
object, as shown in picture.
B. Install new battery by putting one side of the battery
beneath the battery baffl e and then pressing down the
other side.
PIC 2
A. Take out used batteries, with the aid of a sharp object if
needed.
B. Install new batteries by putting one side of the battery
down fi rst and pressing down the other side.
(Please observe the polarity)
■
LCD
Tare Weight
Zero Weight
Negative Value
Mode
Weight unit (kg)
Volume unit (ml)
Volume unit (fl ’oz)
Weight unit (lb:oz)
Weight mode
Milk volume mode
Water volume mode
■
BUTTON
FUNCTION
MODE
: Mode and unit conversion
: Turn on/Turn off /Zero/Tare
■
MODE AND UNIT CONVERSION
After turning on scale, press
MODE
button to select mode and unit, as shown below:
Remark: The unit system of scale depends on sales destination or the requirement of distributor.
■
TO
START
WEIGHING
Load
weighing
object.
1.
Weighing mode
A. Place the scale on a solid and fl at surface.
B. Place bowl (If used) on the scale.
C. Press to turn on the scale.
D. Wait until LCD shows “0”.
Press
MODE
button to convert to weighing mode.
E. Load weighing object on scale (or bowl) to start weighing.
LCD will show the weight reading.
F. If the weighing object is water or milk, press
MODE
button
to choose volume mode and view the volume of weighing
object.
Put a liquid
container.
Pour liquid
2.
Volume indication mode
A. Place the scale on a solid and fl at surface.
B. Press to turn on the scale.
C. Wait until LCD shows “0”, and press
MODE
button to choose “Water”
or “Milk” mode.
D. Put a liquid container onto the scale platform. LCD shows weight of
container.
E. Press button to zero or tare weight.
F. Pour liquid (water or milk) into the container, LCD shows the volume
of the liquid.
G. Press
MODE
button to choose “Weight” mode and view the weight
of liquid.
