- 3 -
MENU: Gallery
Delete file
Delete all
lock file
Unlock file
lock all
Unlock all
MENU: White Balance
White Balance – auto
White Balance – Fluorescent
White Balance – Daylight
White Balance – Tungsten
White Balance – Cloudy
Using the LAMAX DRIVE C7 car camera
1) Inserting Micro SDHC card
Insert or remove the micro sDHC card from the card slot only when the camera is turned off and not connected
to a computer or power supply.
2) Power
a) Camera can be powered using a UsB cable connected to a computer or using the car cigarette lighter.
b) Camera is designed to be powered continuously. Built-in battery can not be removed or replaced.
c) Integrated battery is primarily for use in parking mode.
3) Turning the camera on and off
a) To switch on the camera, press and hold the On/OFF button for 3-5 seconds.
b) Cameras automatically turns on when connected to a power supply.
c) To switch off the camera, press and hold the On/OFF button for 3-5 seconds.
d) Camera automatically turns off after disconnecting the power supply.
4) Changing modes and menu navigation
a) repeatedly tap the “mODe” button to toggle between video/camera/videogallery/photogallery.
b) Camera menu has 4 sections–general settings/video settings/photo settings/language. To toggle between
these use the „UP“ and „DOWn“ arrows and select by pressing. To enter to the each menu push menU button.
Under each section move vertically using the “UP” and “DOWn” arrows and select by pressing “OK”.
c) To independently change the settings in video/photo mode, you must access the settings from the relevant
mode. Therefore, you can only enter video settings in video mode and photo settings in photo mode.
d) To go back a level use the “menU” button. To completely exit the setting, press the “mODe” button.
5) Recording / taking photos / gallery
a) To start the camera recording press the “OK” button. Press it again to stop recording. The camera must be in
record mode.
b) automatic recording – the automatic recording function is always enabled. automatic recording starts after
connecting the camera to a power supply. If the car‘s power only starts after the ignition is turned on then the
camera turns on and starts recording when the car is started.
c) automatically start/stop recording – the camera automatically stops recording and turns off after the engine is
turned off and the power cut. In some cars the cigarette lighter is powered permanently. In this case, be sure to
unplug the cable from the cigarette lighter.
d) Take photos by pressing the “OK” button. The camera must be in photo mode.
