12
13
EN
CS
CS
CZ
CZ
CZ
CZ
CZ
WARNING!
The product creates an electromagnetic field of very weak intensity. However, this field may interfere with
some pacemakers. To reduce the risk of serious or fatal injury, persons with pacemakers should consult their
physician and pacemaker manufacturer regarding vehicle use.
UNPACKING
–
After unpacking the product from the box, carefully inspect all parts.
–
Before disposing of the packaging materials, always carefully check whether any parts of the quad bike
are left inside the packaging.
–
Keep packaging components (plastic bags, clips, etc.) out of reach of children.
–
If the product is damaged during unpacking or if the delivery is incomplete, contact your dealer imme-
diately.
BOX CONTENTS
–
Quad bike body, handlebars and their mounts (2 upper, 2 lower, 4 screws), front and rear protective frame,
front plastic bumper, front right and left wheels, charger, 2 fuses, instruction manual, tools.
–
Standard accessories are subject to change without notice.
–
This product requires assembly. The vehicle must be properly assembled before use.
ASSEMBLY
–
We recommend assembling the quad bike with an experienced mechanic. In the case of assembling the
quad bike yourself, we recommend two people assemble it.
–
Assembly takes approximately 30–40 minutes.
–
The initial battery charge can take up to 12 hours.
–
Do not shorten this charging time!
–
Inflate all 4 wheels to the appropriate pressure (170 kPa / 24 PSI).
–
Unpack the quad bike from the box.
–
Remove the bolts that attach the quad bike to the iron frame (images 1 and 2).
–
Remove all loose parts from the packaging (quad body, front wheels, front plastic bumper, front and rear
metal frame, manual, charger, and a set of screws and tools). See images 3, 4 and 26.
HANDLEBARS
–
Attach the handlebars using the black washers and four screws (images 4 and 5).
–
Tighten the screws carefully.
FRONT WHEELS
–
Install the front wheels and front brake disc (images 6, 7 and 8).
–
Place the wheel on the axle. Pay attention to the roll of the wheel, which is indicated by an arrow on the
outside of the tire.
–
Then fit the brake callipers to the brake disc and tighten all the screws.
–
Tighten the outer wheel bolt properly.
–
Repeat the same for the left and right front wheels (images 9, 10 and 11).
FRONT PLASTIC BUMPER
–
Remove the screws from the front metal structure (image 12). Use these screws to attach the front plastic
bumper (image 13).
FRONT METAL FRAME
–
Unscrew the two screws from the plastic top cover (image 15).
–
Attach the front metal frame to the plastic bumper (images 16 and 17).
–
Attach the front metal frame to the upper plastic cover with screws (image 18).
REAR METAL FRAME
–
Attach the rear metal frame to the rear of the quad bike (image 19).
–
Remove the screws from the main frame and use them to attach the rear metal frame (images 20 and 21).
Summary of Contents for eTiger ATV50S BLUE
Page 2: ......
Page 5: ...CZ CZ 13 14 15 16 17 18 19 20 21 25 26 22 23 24...
