Printed 07-2001
-6-
Form No. M1-0002
ASSEMBLY:
INSTALL HEIGHT ADJUST STRAP AND HAMPER SUPPORT STRAP
LOCATE THE FOLLOWING:
1 ............................................ Height Adjustment Strap (14)
1 ...............................................................Carriage Bolt (13)
1 ....................................................... 5/16-18 X 3/4 Bolt (30)
1 .............................................................. 5/16 Pilot Nut (51)
1 ........................................................ 5/16 Flat Washer (21)
1 ....................................................... Adjustment Knob (16)
1 ......................................................... 3/8 Flat Washer (15)
1 ..................................................... 5/16 Lock Washer (37)
1 .............................................. Hamper Support Strap (46)
1) From inside of chassis (1) insert Bolt (30) through Hamper Support Strap (46) (in hole closest to small notch, with
notches pointing upward) then through hole “A” on chassis. Insert Lock Washer (37) over Bolt (30). Install hole on Height
Adjustment Strap (14) over Bolt (30). Install Pilot Nut (51) onto Bolt (30) with hex on the outside and secure loosely.
2) Line up slot on the Height Adjustment Strap (14) with square hole on Height Adjustment Lever Arm (12) and insert
Carriage Bolt (13) from the inside through Height Adjustment Lever Arm (12) and Height Adjustment Strap (14). Install
3/8 Flat Washer (15) over Carriage Bolt (13), and install Height Adjustment Knob (16).
