CYC
HRS
Display
The control and command panel makes 3 display methods available:
NORMAL:
in this mode, icons appear on the display that are relative to the burner functioning state.
If there are no anomalies present, the display shows the number of ignition cycles performed by the burner and
the total number of functioning hours.
If an anomaly occurs, the display shows the relative code and signals the type of anomaly, (volatile or non-
volatile).Additional information regarding the burner status is also displayed (e.g. valves sealing control proce-
dure) and any execution of special functions for enabled staff.
MENU:
by pressing key i during the normal display mode, access the list of menus:
- INFO (Information)
- HIST (Anomalies log)
- PARAM (Parameters)
- SERV (Installer)
Use the + and - keys to scroll the list.
Press key i again to access one of the menus.
To exit the menu or the list of menus, press R or wait 60 s without pressing any buttons to go back to the normal
display.
MODIFY PARAMETER:
The values of the parameters linked to burner functioning can be modified and memorised.
During the display of the parameter of interest, it is possible to access the value modification by pressing key
i.
In this phase the current parameter value starts to flash and by pressing the + and – keys it is possible to mo-
dify the value.
Press key i to save the modified value.
To exit the parameter modification mode without saving, wait 10s without pressing any buttons or press the R
key.
Normal display mode
By connecting the GB2 board to the mains power supply, the CP45 interface is automatically powered, which for
a few seconds switches on all icons and segments of the display in order to check correct functioning.
When this has been carried out, automatic access is given to the NORMAL DISPLAY mode, during which, in
absence of anomalies, the icons are switched on and off in relation to the functioning of the various burner com-
ponents.
Also with no anomalies present, the total number of ignition cycles performed is displayed along with the total
functioning hours of the burner.
