- 35
-
ENGLISH
2) Open the burner.
Unscrew screws E for models 50-75-100
E’ for models 30-130
Disengage electrode wires, slide off resistances VE1 and VE2 and the head
from their relative seats.
3) Slide off piston support.
CLEANING THE NOZZLES
- Unscrew the nozzle using the wrench included and remove the filter;
- Use an Allen wrench to unscrew the nozzle dispenser (fig. 18);
- Rinse both very well and for a long time using gasoline and diesel;
- Without using needles or anything similar make sure that the gasoline or the
diesel can flow freely through the nozzle orifice by tapping it gently with your
index finger (fig. 20), and that grooves are perfectly clean (fig. 19).
- Reassemble nozzle components without excessive tightening; screw the nozz-
le back on the burner and tighten it well.
E
E'
FIG. 16
FIG. 17
FIG. 18
FIG. 19
FIG. 20
