14
IGNITION - OPERATION - SHUTDOWN INSTRUCTIONS
IGNITION
Open the gas tap and tun the selector switch (6) to the desired position. The burner will ignite automatically.
Should ignition fail to take place check the lock-out warning light (1) and fault warning light (3) to see if they
have come on. Turn the selector (6) to the reset position A. Then rotate the selector (6) again to the desired
position. Then adjust heating temperature (4) and hot water temperature (5) as desired via the appropriate
controls.
TEMPORARY IGNITION/SHUTDOWN
Proceed as follows:
●
adjust the room thermostat;
●
adjust the potentiometers on the front panel (4) (5).
PROLONGED SHUTDOWN
Should the boiler remain idle for a long period close the gas tap, position the selector switch (6) at position (0)
and disconnect the electrical power supply.
SUMMER MODE
Turn the selector switch (6) to SUMMER.
Regulate the hot water potentiometer (5) to a position corresponding to desired water temperature.
WINTER MODE
Turn the selector switch (6) to WINTER.
Regulate the heating potentiometer (4) to a position that corresponds to desired heating temperature.
If a room thermostat is installed then the thermostat will keep room temperature at the set level.
Adjust the hot water potentiometer (5) to a position corresponding to desired water temperature.
IMPORTANT:
XILO M boilers are fitted with FLUE CONTROL to monitor flue draught. This safety device shuts down the boiler
if there is a risk of combustion fume backflow into the room. This device must never be deactivated. If combustion
fumes re-enter the room they may cause chronic or acute intoxication that can be fatal. If the Flue Control
device is changed use only original spare parts.
If the device trips repeatedly contact a Lamborghini Service Centre.
WARNING: When Summer or Winter mode is selected the ON indicator light comes on indicating
that the boiler is electrically powered.
WARNING: Use only 2A/250VC - 5x20 rapid fuses.
