LAMBORGHINI thin 24 MCS W TOP U/IT, Installation And Maintenance Manual

21

“AUTOMATIC” TEMPERATURE CONTROL MODE

The control unit has a daily/weekly timer that automatically adjusts room temperature to “comfort” or “low

temperature” values over a 24 hour period, with independent settings for each of the seven days.

To enable automatic operation press the  

  key and the  

  symbol will be displayed.

Hourly programming of temperature values is only permitted with the Heating or Hot water/Heating functions

enabled.

●

HOURLY PROGRAMMING OF TEMPERATURE VALUES

Press key 

V 

to select the desired day on the  

  indicators.

The display will then show the programme graph for the selected day by displaying the “indicator lights”

next to the “comfort” level.

To modify these settings press 

P

 within 5 seconds.

The time “00:00” will now appear on the display and the indicator light corresponding to that time will

begin to flash.

Press the 

+

 and 

–

 keys to increase or decrease the time in 30-minute steps.

The  

  and  

   symbols show the present value of the indicator light (  

  comfort temperature

level and  

  low temperature level)

Select the desired value by acting on the  

   (comfort temperature level) and  

  (low tempera-

ture level) keys. The indicator light will take on the desired value and programming will advance by one

step: the next indicator light to be programmed will then flash.

Once programming is over press 

P

 to memorise settings or 

V

 to cancel the modifications.

The timer can memorise up to 48 daily temperature value changes.

●

COPYING HOURLY PROGRAMMING

To speed up programming, you can “paste” the settings for a specific day onto another day.

Press 

V

 to select the day from which you wish to copy the settings.

Press the 

Copy

 key within 5 seconds to copy and then press the 

+

 and 

–

 keys to select the page onto which

you intend to “paste” them (the “destination” day is indicated by a flashing  

  indicator).

Press 

P

 to paste and memorise the settings or 

V

 to cancel.

●

TEMPORARY TEMPERATURE VARIATION

It is possible to vary set room temperature during automatic temperature control mode by acting on the 

+

and 

–

 keys. Variations will be shown on the display.

When this function is used the symbol indicating the present level goes out and the indicator light corresponding

to the relevant time slot starts flashing.

The new temperature will remain operative until the next value change, after which the programme will revert

to normal settings.

36

Manteniendo presionado el botón  

, presione los botones 

+

 y 

-

 para programar la temperatura

deseada.

Soltando el botón  

  la programación será memorizada.

VISUALIZACIÓN DE LOS PARÁMETROS Y ESTADO DE LA CALDERA

Presionando varias veces el botón     se pueden visualizar, en la secuencia abajo indicada, los parámetros

principales de la caldera.

Parámetros visualizados:

-

Temperatura efectiva del agua de calefacción (símbolo  

  intermitente)

-

Temperatura efectiva del agua caliente sanitaria (símbolo  

  intermitente)

-

Temperatura ambiente programada en base al nivel actual (símbolo  

  intermitente)

-

Temperatura externa (símbolo  

  intermitente)

Si no hay una sonda externa la pantalla indica “

—:—

“

-

Presión del agua en la instalación (símbolo  

  intermitente)

Si no hay un presostato para el agua la pantalla indica “

—:—

“

El símbolo     encendido indica que está funcionando el “circ. sanitario” o la “calefacción”.