2
Dear Customer, thank you for choosing one of our products, which is a result of technological expertise and our
continuous quest for superior products in terms of safety, reliability and performance. This manual contains all the
information and helpful tips for using your product with maximum safety and efficiency.
IMPORTANT INFORMATION
This manual has been prepared by the manufacturer and is an integral and essential part of the product. In
the event of sale or transfer of the product, always ensure the presence of the manual as the information it
contains is addressed to the purchaser and to all those various people involved in the installation, use and
maintenance of the product. Carefully read the instructions and information contained in this manual before
installation, operation and maintenance of the product. The instructions contained in this instruction manual
guarantee the safety of persons and property and ensure efficient operation and a longer service life. The
manufacturer declines all responsibility for damage caused by failure to observe instructions regarding
installation, use and maintenance listed in the instruction manual, for unauthorised modifications or non-
original replacement parts. Product installation and use must be carried out in accordance with the
manufacturer's instructions and in compliance with European, national and local regulations. Installation,
electrical connection, functional testing, maintenance and repairs are operations that must be performed by
qualified and licensed personnel who must have appropriate knowledge of the product. Product installation
must not be carried out close to walls made of wood or combustible material. For proper installation, you must
observe the following "Safety distances" section. Verify the exact flatness of the floor where you will install
the product. When handling the steel parts of the cladding, use clean cotton gloves to avoid leaving difficult
to remove fingerprints for the first cleaning. Stove installation must be performed by at least two people.
Connect the stove to the mains only after proper professional connection to the chimney flue. The power
cable plug must remain accessible after installation of the stove. Only operate the stove with regulation wood
pellets (refer to the "FUEL" chapter). Never use liquid fuels to operate the pellet stove or to stoke the embers
present. Provide adequate ventilation in the installation area throughout the year. In the presence of operation
failures, fuel supply will be interrupted. Re-start the unit after removing the cause of the failure. Discontinue
use of the product in the event of failure or malfunction. Do not remove the safety guard located in the pellet
tank. Any accumulated unburned pellets in the burner as a result of repeated "failed ignitions must be
removed prior to ignition." Pellet stove operation can cause very hot heating of the handles, the chimney flue
and glass surfaces. Only touch these parts during operation when wearing protective clothing or with
adequate aids. Because of the creation of heat on the glass, make sure that no persons unfamiliar with stove
operation stand in the installation area. Inform children of the precautions to be observed during product
operation and of possible dangers. In the event of problems or misunderstanding of the instructions manual,
contact your dealer. Placing objects which cannot withstand heat on the stove or within the minimum required
safety range is prohibited. Do not open the door during operation or operate the stove with its glass broken.
For product terms, limitations and exclusions, please refer to the warranty included with the product. In order
to pursue a policy of constant product development and renewal, the manufacturer may make changes to it
as deems appropriate without notice. This document is the property of the manufacturer and cannot be
disclosed in whole or in part to any third party without the written consent of the company, which reserves all
rights to the rigor of the law.
GUIDELINES AND STANDARDS
All our products are manufactured according to
the following guidelines:
in compliance with the following standards:
89/366 CEE
2004/108 CE
2006/95 CE
89/106 CEE
EN 60335-1; EN 60335-2-102
EN 61000-3-2; EN 61000-3-3
EN 50366; EN 55014-1 ; 55014-2
EN 14785 l
