17_
Gas Connection
These instructions are for qualifi ed personnel,
installation of equipment must be in line with
relevant national standard.
(For U.K only: by
law the gas installation\commissing must be
carried out by a “Gas Safe” installer).
All work must be carried out with the electricity
supply disconnected.
The rating plate on the hob shows the type
of gas with which is it designed to be used.
Connection to the mains gas supply or gas
cylinder should be carried out after having
checked that is regulated for the type of gas with
which it is supplied. If it is not correctly regulated
see the instructions in the follwoing paragraphs
to change gas setting.
For liquid gas (cylinder gas) use pressure
regulators which comply with the relevant
national standards.
Use only pipes, washers and sealing washers
which comply with relevant national standards.
For some models a conic link is furnished to
outfi t for the installation in the countries where
this type of this link is obligatory: in the image
below it is pointed out how to recognise the
different of links (CY= cylindrical, CO= conic). In
every case the cylinderical part of the link has to
be connected to the hob.
When connecting the hob to the gas supply via
use semi-rigid hoses please ensure that the
maximum distance covered by the hose does
not exceed two metres.
Cylindrical
Conical
Adapting the hob to different
types of gas
To adapt the Hob for use with different types of gas,
1. Flame failure device
2. Spark plug
3. Injector
4. Burner
carry out the following instructions:
Remove the grids and burners
Insert on hexagonal spanner (7mm) into the
burner support
Unscrew the injector and replace it with one
suitable for the gas to be used
(see gas type table)
To adapt the Hob for use with different types of gas,
carry out the following instructions:
Remove the grids and burners
Insert on hexagonal spanner (7mm) into the
burner support
Unscrew the injector and replace it with one
suitable for the gas to be used
(see gas type
table)
To replace the injectors with injectors of a size
corresponding to the type of gas to be used, see the
table below.
NOTICE
If the gas type of the unit is changed, then the rating
*Depends upon model type
plate that shows the gas type of the unit must also
be changed.
User manual LAM1111
