12_
LAMONA
Appliances
Typical Installation positions
Typical Installation positions
Seal
Underside of hob
Place the hob in the aperture, checking the hob
glass is covering the worktop along all four sides.
Set the front edge of the appliance parallel with the
front of the worktop.
Secure the hob to the worktop by means of the
brackets provided, taking the thickness of the
worktop into account. Depending on your appliance
it will be supplied and installed using one of the
following installation methods.
Method 1
The brackets screw directly into the base of the hob
in the positions shown
40mm
Hob
Worktop
Screw
50mm
Hob
Worktop
30mm
Hob
Worktop
Screw
Installation above an oven
If the appliance is installed with an oven
underneath, please leave atleast 25mm of
ventilation, umless otherwise stated in your oven
installation guidelines.
Worktop
25mm
oven or partition
Hob
Connect to the electricity Supply
This appliance must be earthed.
The hob must be installed by a competent
electrician, using a suitable double pole control unit,
with 3mm minimum contact separation at all poles.
Connection should be made with a suitable cable.
Ensure that you route all mains electrical
cables well away from any adjacent heat source,
such as the base of the hob or oven / grill surface.
Strip the wires & connect to the terminal
block as appropriate:-
Installation
