20
2) Extend the angle bars to the required height, then
fix them in position using the 10 mm x M4 nuts and
bolts with metal washers (12 pcs) (as shown in the
line drawing opposite).
o
IMPORTANT:
The angle bars must have an
overlap of
AT LEAST 100 mm
.
o
Fix a connector piece to the
bottom of each angle bar using
the 10 mm x M4 nuts and bolts
with metal washers (12 pcs).
3) Place the angle bars inside of the
main body of the cooker hood.
Place the upper chimney section onto
the main body of the cooker hood.