Battery
Connecting The Remote Control
The remote control requires a CR2025 battery. The battery can be accessed fromthe bottom, as shown in
the below picture.
Carefully release the tab and
pull the battery tray out.
A new remote control has to estabish a connection to the cooker hood when used for the first time.
(One remote control could possibly control several cooker hoods at the same time).
Connection Process Between Remote Control And Cooker Hood:
1. Press any button on the LCD touch control panel on the cooker hood, the backlight display is lit and the
cooker hood is in stand-by mode.
2. Press for 10 seconds, the indicator lights begin flashing from one button to another:- the cooker hood
is in connection mode. The press any button on the remote control to confirm the connection. The connection
process is finished and the remote can be used for speed selection, lighting and timer setting.
3. If you want to connect again you will need to clear the code that has been
entered previously:
To clear: Press the for 10 seconds, the indicator lights begin flashing one button to another:- the
cookeris in connection mode. Then, press the for 10 seconds immediately again: the previous
connection code is cleared
To After the previous connection code is cleared. Press for 10 seconds:- the indicator lights begin
flashing from one button to another:- the cooker hood is in connection mode. Then press any button of the
remote control to confirm connection.
Page _ 10
www.howdens.com
LAMONA
Appliances
