18
19
www.howdens.com
Built-Under Larder Fridge
LAM6000
Instructions and Installation
Replacing the interior light bulb (See diagram)
1
4
DO'S AND DON'TS
Do-
-Clean your larder refrigerator regularly.
-Store raw meat in the lower part of the refrigerator
below cooked food and dairy products
-Wrap and cover all items to prevent 'drying-out' and to
avoid smell and cross contamination.
-Store food as short a time as possible to avoid bacterial
growth.
-Keep the refrigerator sufficiently cool to inhibit bacterial
growth.
-Observe use-by dates on foodstuffs.
-Clean salad and remove damaged leaves
-Leave lettuce, cabbage and cauliflower on the stem.
-Wrap cheese in greaseproof paper and polythene,
removing as much air as possible.
-Try not to overload the door trays.
-Store bananas in your fridge.
- S
tore melon in your fridge. It can be chilled for short periods
as long as it is wrapped to avoid it flavouring other food.
- Leave the door open for long periods as this will make the
larder refrigerator more costly to run.
- Store poisonous or any dangerous substances in the larder
refrigerator. (Your larder refrigerator has been designed for
the storage of edible foodstuffs only).
- Consume food which has been stored for an excessive time
in the larder refrigerator.
- Store cooked and fresh food together in the same container.
They should be packaged and stored separately
-
Let defrosting food or food juices drip onto food below.
PROBLEM SOLVING/TROUBLE SHOOTING
If the appliance does not operate when switched on, check;
•
The plug is inserted properly in the socket and that the power
supply is on.
•
If the fuse has blown/circuit breaker has tripped/main switch
has been turned off.
•
The temperature control has been set correctly.
(Checking these items may avoid a charge if a guarantee
service call is made)
1
5
REPLACING THE INTERIOR LIGHT BULB (See diagram)
Should the light fail to work, switch off at the plug socket and pull
out the plug. Follow the instructions below to check if the light bulb
has worked itself loose or needs replacing.
If the light needs replacing, fit a suitable E14 screw cap type 15w
(Max) lamp. (Available from Lamona spares)
Replace as follows:
1.
Switch off at the plug socket and pull out the plug.
2.
Remove the light diffuser cover as shown in figure (b-c).
(You may find it useful to remove the shelf for easy access.)
Replace the failed lamp.
3.
Re-fit the light diffuser cover as shown in figure (d).
Push firmly to ensure cover is fitted properly.
4.
Carefully dispose of the failed lamp.
a
b
c
d
1
2
3
Push firmly
Don't-
Should the light fail to work, switch
off at the plug socket and pull out
the plug. Follow the instructions
below to check if the light bulb
has worked itself loose or needs
replacing.
If the light needs replacing, fit
a suitable E14 screw cap type
15w (Max) lamp. (Available from
Lamona spares)
Replace as follows:
1.
Switch off at the plug socket
and pull out the plug.
2.
Remove the light diffuser cover
as shown in figure
B
-
C
.
(You may find it useful to
remove the shelf for easy
access.) Replace the failed
lamp.
3.
Re-fit the light diffuser cover as
shown in figure
D
.
Push firmly to ensure cover is
fitted properly.
4.
Carefully dispose of the failed
lamp.
To avoid any loss in performance, air suction channels should not be
obstructed. (140cm
2
) Minimum distance between the wall and the
appliance must be at least 10 mm.
6
7
•
The appliance should be transported only in a vertical upright
position.
•
If during the course of transport the appliance has to be
transported horizontally, it must only be laid on its left hand
side (when standing in front of the appliance). After bringing it
to upright position,it must not be operated for at least 4 hours
to allow the cooling system to settle.
•
Failure to comply with the above instructions could result in
damage occuring to the appliance. The manufacturer will not be
held responsible if these instructions are disregarded.
•
The appliance must be protected against rain, moisture and
other atmospheric influences.
•
Empty any water in the drain tray before moving see section
“Defrosting” and “Cleaning & Care” for further information.
IMPORTANT
:
To avoid any loss in performance, air suction channels should
not be obstructed. (140 cm 2) Minimum distance between the
wall and the appliance must be at least 10 mm.
•
Correct adjustment of feet avoids excessive vibration and noise.
•
Refer to "Cleaning and Care" section to prepare your appliance for
use.
•
This appliance has been designed to operate in ambient temperatures
b10 and +32 degrees C. if the appliance is installed in an
unheated / cold room (E.g.: garage etc.) then the appliance may not
operate correctly and as a result; the storage time of food may be
reduced.
10 mm
10 mm
Wall
Appliance
TRANSPORT
TRANSPORTA
ATION INSTRUCTIONS
TION INSTRUCTIONS
•
Make sure the plastic evaporating pan at the back of the
product is located correctly before installation.
•
Care should be taken with the grilles and pipework at the rear
of the appliance to avoid damage to the product and person.
•
This appliance is not designed for stacking with another
appliance.
•
Do not trap and damage mains cable under appliance,
•
Do not allow children to play with the appliance or controls.
•
Do not sit or stand on appliance
INSTALLATION INSTRUCTIONS
•
Do not operate this appliance unless installed
in
to furniture.
•
The appliance should be located on a smooth solid surface.
•
The front and back feet can be adjusted as required to ensure
that the appliance is standing plumb and level.
6
7
•
The appliance should be transported only in a vertical upright
position.
•
If during the course of transport the appliance has to be
transported horizontally, it must only be laid on its left hand
side (when standing in front of the appliance). After bringing it
to upright position,it must not be operated for at least 4 hours
to allow the cooling system to settle.
•
Failure to comply with the above instructions could result in
damage occuring to the appliance. The manufacturer will not be
held responsible if these instructions are disregarded.
•
The appliance must be protected against rain, moisture and
other atmospheric influences.
•
Empty any water in the drain tray before moving see section
“Defrosting” and “Cleaning & Care” for further information.
IMPORTANT
:
To avoid any loss in performance, air suction channels should
not be obstructed. (140 cm 2) Minimum distance between the
wall and the appliance must be at least 10 mm.
•
Correct adjustment of feet avoids excessive vibration and noise.
•
Refer to "Cleaning and Care" section to prepare your appliance for
use.
•
This appliance has been designed to operate in ambient temperatures
b10 and +32 degrees C. if the appliance is installed in an
unheated / cold room (E.g.: garage etc.) then the appliance may not
operate correctly and as a result; the storage time of food may be
reduced.
10 mm
10 mm
Wall
Appliance
TRANSPORT
TRANSPORTA
ATION INSTRUCTIONS
TION INSTRUCTIONS
•
Make sure the plastic evaporating pan at the back of the
product is located correctly before installation.
•
Care should be taken with the grilles and pipework at the rear
of the appliance to avoid damage to the product and person.
•
This appliance is not designed for stacking with another
appliance.
•
Do not trap and damage mains cable under appliance,
•
Do not allow children to play with the appliance or controls.
•
Do not sit or stand on appliance
INSTALLATION INSTRUCTIONS
•
Do not operate this appliance unless installed
in
to furniture.
•
The appliance should be located on a smooth solid surface.
•
The front and back feet can be adjusted as required to ensure
that the appliance is standing plumb and level.
3. Installation
3
Exclusive to Howdens
Dear Customer
Congratulations on your choice of energy efficient larder fridge.
• Please read these instructions before use to ensure safe and economical
operation of the larder fridge.
• Please keep these instructions in a safe place for your future reference.
• If you have any questions, or if you are not sure about any information
contained in this booklet please contact us - details at the end of the User
Instructions.
This appliance is intended to be used in household and similar domestic
applications, see guarantee page for definition of domestic use*.
Welcome
Warning for hazardous
situations with regard to
life and property.
Warning for
electric shock.
Warning for
risk of fire.
Throughout this manual the
following symbols are used.
Installation Instructions
• Do not operate this appliance
unless installed into furniture.
• The appliance should be
located on a smooth solid
surface.
• The front and back feet can be
adjusted as required to ensure
that the appliance is standing
plumb and level.
• Correct adjustment of feet
avoids excessive vibration and
noise.
• Refer to ‘
Cleaning and Care
’
section to prepare your
appliance for use.
• This appliance has been
designed to operate in ambient
temperatures b10 and
+32 degrees C. if the appliance
is installed in an unheated / cold
room (E.g.: garage etc.) then
the appliance may not operate
correctly and as a result; the
storage time of food may be
reduced.
A
B
C
D
