Lamona NBT625/2NX, Instruction Manual

9 

4. The power will be connected when pull out the front panel. Conversely, the 
power will be automatically disconnected. 
 

TROUBLESHOOTING 

Fault 

Possible Cause 

Solution 

Light on, but motor 
does not work 

Fan switch turned off 

Select a fan switch position. 

Fan switch failed 

Contact service center. 

Motor failed 

Contact service center. 

Light does not 
work, motor does 
not work 

House fuses blown 

Reset/Replace fuses. 

Power cord loose or 
disconnected 

Refit cord to power outlet. 
Switch power outlet on. 

Oil leakage 

One way valve and the outlet 
are not tightly sealed 

Take down the one way valve 
and seal with sealant. 

Leakage from the connection of 
chimney and cover 

Take chimney down and seal. 

Lights not working 

Broken/Faulty globes 

Replace globes as per this 
instruction. 

Insufficient suction 

The distance between the 
cooker hood and the gas top is 
too far 

Refit the cooker hood to the 
correct distance. 

The Cooker hood 
inclines 

The fixing screw not tight 
enough 

Tighten the hanging screw and 
make it horizontal. 

NOTE:  

Any electrical repairs to this appliance must conform to your local, state and 
federal laws.Please contact the service centre if in any doubt before 

undertaking any of the above.Always disconnect the unit from the power source when 
opening the unit. 
 

MAINTENANCE AND CLEANING

Caution:

• Before maintenance or cleaning is carried out, the cooker hood 

should be disconnected from the main power supply. Ensure 
that the cooker hood is switched off at the wall socket and the 
plug removed. 

 
• External surfaces are susceptible to scratches and abrasions, so please follow the 

cleaning instructions to ensure the best possible result is achieved without damage.