MEASUREMENT 6 SETTING
Directions for entering the
maintenance mode are on page 19.
Erikoishuolto
Aset.palautus
Asetusarvot
Mitt. asetukset
Meas. 6 setting
Measure 6
H2 Room temp
Wind meas.
Sun meas.
Not connected
Comp/Meas. data
Min /
0%
Max /
100%
More information about sun and wind sensor connection on the next page
Labeling measurement 6 using the text editor:
The factory setting for measurement 6 is
"Measure 6".
Relabeling is shown on page 9.
Press
Press the or
button to set a limit and
press
to confirm.
OK
.
-
+
OK
The
character indicates which measurement has been chosen for
measurement 6.
Selecting measurement 6:
Setting limits for the wind or sun sensor measurement message:
You must set compensation limits for wind or sun measurements. The
minimum indicates where in the transmitter's measurement area the
compensation begins and the maximum indicates at which
measurement area the compensation is at maximum value.
Name change
Measure 6
Give new label
Special mainten.
Rstore settings
Settings
Meas. 6 setting
Meas.11 setting
In this special maintenance mode, measurement 6 can be
changed from just a free temperature measurement to a regulating circuit
H2 room compensation measurement or a regulating circuit H1 and H2
wind or sun compensation measurement. Free temperature measurement
is a factory setting which is labeled "Measure 6". This label can be
changed
using the text editor.
Press the
button to move the cursor to what you want to connect to
measurement 6. Press
OK
.
Press the
button to move the cursor to "Meas. 6 setting". Press
OK
.
31
