English
4
/ 44
EN
FR NL DE ES IT PL CS SK SL HR BG
ENGLISH
INTRODUCTION
Thank you for choosing the NAPO cool and
warm mist humidifier by LANAFORM. The
NAPOhumidifier helps you restore a proper
humidity level and eliminate the discom-
fort associated with dry air. The ventilation
system diffuses water in the form of cool or
warm mist, thus providing the level of hu-
midity required. This vapour takes the form
of a mist released from a diffusion nozzle.
camera_alt
The photographs and other
images of the product in this
manual and on the packaging
are as accurate as possible, but
do not claim to be a perfect
reproduction of the product.
report_problem
PLEASE READ ALL THE
INSTRUCTIONS BEFORE
USING YOUR HUMIDIFIER,
ESPECIALLY THIS BASIC
SAFETY INFORMATION:
• This device is not intended for use by
people, including children, with reduced
physical, sensory or mental capabilities,
or people with a lack of experience or
knowledge, unless someone respon-
sible for their safety can supervise or
instruct them beforehand on how to
use the device. Children should be su-
pervised to make sure they do not play
with the device.
• Use this device only according to the
instructions given in this manual.
• Check that your mains voltage is the
same as that of your device.
• Always place the NAPO humidifier on a
hard, flat and horizontal surface. Keep it
away from walls and heat sources such
as stoves, radiators, etc.
• Please note: If it is not placed on a hori-
zontal surface, the device may not work
properly.
• Do not connect or disconnect the mains
plug of the device with wet hands.
• If the power cable is damaged, it must
be replaced by a similar cable availa-
ble from the supplier or the supplier’s
after-sales department.
• Do not leave the device exposed to
direct sunlight.
• Fill the reservoir with fresh, distilled or
demineralised water.
• Do not take the device apart either as a
whole or even its base unit.
• Do not switch on the device when there
is no water in the reservoir.
• Do not shake the device. This could
cause the water to spill over into the
base unit and prevent the device from
working.
• Never touch the water or components
when the unit is running.
• If there is an unusual smell when the
device is being used as described in this
manual, switch off the device, unplug it
and have it examined by the supplier or
the supplier’s after-sales department.
• Do not pour hot water, i.e. water with
a temperature above 40°C, into the
reservoir.
• Unplug the device before cleaning it or
removing the reservoir.
• Do not wash the entire unit with water
and do not immerse it in water. Consult
the cleaning instructions in this manual.
• Never scrape the transducer with a
hard tool. The NAPO humidifier must
be cleaned regularly. To do this, consult
the cleaning instructions in this manual
and follow them.
• If it falls into water, unplug it immedi-
ately before retrieving it.
• Electrical appliances should never be
left unattended when connected. Un-
plug it when you are not using it.
• Keep the power cable away from hot
surfaces.
• Never use this appliance in a room in
which aerosols (sprays) are used or
where oxygen is administered.
• Do not put items of clothing or towels
on top of the device. If the nozzle is ob-
structed, this may cause the device to
malfunction.
• When moving the device, lift it up by
the base and not by the water reservoir.
• Do not use the humidifier if the air in
the room is already sufficiently humid
(relative humidity of at least 50%). The
ideal relative humidity level for human
comfort is in fact between 40% and 60%.
Excess humidity manifests itself in con-
densation on cold surfaces or on cold
walls in the room. To measure the room’s
humidity correctly, use a hygrometer
available in most specialist shops and
hypermarkets.
• The NAPO humidifier is designed for
indoor and domestic use only.
COMPONENTS OF
THE DEVICE
insert_photo
1
(1) Diffuser sprinkler tip
(2) Reservoir cover
(3) Ring seal
(4) Handle
(5) Water reservoir
(6) Exhaust vent
(7) Base
(8) Tray for essential oil
(9) Air inlet
(10) Transducer
(11) Heat resistor
(12) Cleaning brush
DEVICE DISPLAY
insert_photo
2
(1) ON/OFF
(2) Atmospheric light & Night mode
(3) Warning function
(4) Timer
(5) Humidity level control
(6) Emission intensity
INSTRUCTIONS FOR USE
Features
• Cool and warm mist humidifier
• LCD touch screen
• Automatic detection and display of
ambient relative humidity
• Capacity for programming desired hu-
midity level
• Timer: 12 hours with programming in
1-hour stages
• 3 levels of vapour emission intensity:
high, low, medium
• 3 light modes: changing colour, fixed
colour, no light
• Night mode
• Reservoir capacity 4,5l
• Maximum flow rate of cool mist: 300ml/
hr (cool mist) and 400ml/hr (warm mist)
• Automatic shutoff when the reservoir
is empty
• Quiet operation (≤35dB)
Differences between
warm mist and cool mist
Young children
Make the use of cool mist your preference
as it does not cause burns if the device is
dropped or overturns.
Maintenance
The device diffusing cool mist needs to be
cleaned more regularly than a device dif-
fusing warm mist. In fact, when warm mist
is produced, the water is heated through a
heat resistor, thus removing a large quanti-
ty of bacteria. Since the NAPO offers both
these functions, it will be very important to
refer to the care instructions in this manual.
Room in which the humidifier
will be installed
The cool mist will provide a touch of fresh-
ness in a sweltering, dry and badly ventilat-
ed room. Warm mist will itself help reheat
the air in a cold room.
