7
· E
N
G
LI
SH
EN
• After it has been used a certain num-
ber of times, you may notice a swell-
ing which prevents the hot water bottle
charging normally. This normal physical
phenomenon is due to variations in tem-
perature and pressure within the sealed
pouch, creating an accumulation of air.
To remedy this, simply expel the air from the
pouch. To do this, first remove the connector
cover using a Phillips screwdriver, then remove
the silicone stopper using pliers if necessary.
Expel as much air as possible and then replace
the stopper and connector cover.
Storage
Put the belt and the electric hot water bottle
in their box or in a dry place.
Avoid contact with sharp edges and other
pointed objects, which might cut or pierce
the fabric surface.
To prevent the charger's power cable break-
ing at any point, do not wind it up.
Make sure that the belt and hot water bottle
are dry before storing them.
Cleaning
Unplug the hot water bottle from the charger
plug and wait a few minutes before cleaning it.
Clean it using a soft, slightly damp sponge.
Do not immerse it in liquid to clean it.
Never use abrasive detergents, brushes or a
thinning agent to clean it.
Technical spec-
ifications
• Voltage: 220-240V~
• Frequency: 50/60Hz
• Power: 440W
• Composition of the outer lining:
45% recycled polyester, 55% cotton
• Composition of the inner lin-
ing: 100% polypropylenee
Troubleshooting
The hot water bottle
inflates and does not
heat up properly.
• Changes in atmospheric pres-
sure may cause air to accumu-
late in the hot water bottle.
• Carefully remove excess air from the hot
water bottle by first removing the con-
nector cover using a Phillips screwdriv-
er. Then remove the silicone stopper us-
ing pliers if necessary. Expel as much
air as possible and then replace the sil-
icon stopper and connector cover.
Advice regarding
the disposal
of waste
All the packaging is composed of materials
that pose no hazard for the environment and
which can be disposed of at your local sorting
centre to be used as secondary raw materials.
The cardboard may be disposed of in a paper
recycling bin. The packaging film must be tak-
en to your local sorting and recycling centre.
When you have finished using the device, please
dispose of it in an environmentally friendly way
and in accordance with the law.
Limited warranty
LANAFORM guarantees this product against
any material or manufacturing defect for a pe-
riod of two years from the date of purchase,
except in the circumstances described below.
The LANAFORM guarantee does not cover
damage caused as a result of normal wear to
this product. In addition, the guarantee cov-
ering this LANAFORM product does not cover
damage caused by abusive or inappropriate
or incorrect use, accidents, the use of unau-
thorized accessories, changes made to the
E-IM-WaistWarmerGo-Lot001.indd 7
E-IM-WaistWarmerGo-Lot001.indd 7
11/08/2021 11:27:13
11/08/2021 11:27:13
