6
Lumi Lamp
Version 01 Lot001 - 24/06/2015
INSTRUCTIONS FOR USE
• The Lumi Lamp should be used preferably during the day and not in the evening.
Installation:
1.Place your Lumi Lamp on a solid, flat and stable surface.
2.Your face should be between 15 and 30cm away from the Lumi Lamp.
3.Plug the power cable into a socket corresponding to the product’s rating plate.
- Make sure that the socket is near the Lumi Lamp.
- Lay out the power cable so that no-one trips over it.
- To prevent any risk of strangulation, keep the cable out of the reach of young children.
Use:
•You can switch on the Lumi Lamp using the (On/Off) button.
•The recommended exposure time to the Lumi Lamp depends on the distance from the lamp and the light intensity selected. The general advice, however, is that the device
should be used for 1 hour at a light intensity of 5000 Lux. You can therefore easily calculate the recommended exposure time from the table below:
Distance
Lux
Exposure time
10cm
10,000
+/- 30 mins.
15cm
5,700
+/- 1hr
25cm
2,600
+/- 2 hrs
•Sit down in front of the device.
o The distance between your face and the screen should be between 15 and 50cm. Adjust as required and so that your eyes are comfortable.
o You are not obliged to sit directly opposite the device.
o You can space out the length of your light therapy session.
• Exposure must be regular for a prolonged period. Throughout the darkest days of the year, repeat the therapy for at least 7 consecutive days and more, according to individual
requirements.
- The light tube is at full power after a few minutes.
- Stop the machine after use by turning the button to the “0” position on the front of the device and unplug it. Wait for 10 minutes before replacing the
product in its package.
- If, during the exposure to light session, your eyes ache or you feel any other pain, stop using the Lumi Lamp immediately and consult your doctor.
- Do not look at the lamp directly. You can read, write, make telephone calls etc. during the session.
MAINTENANCE AND STORAGE
Cleaning:
• Unplug the device and allow it to cool down.
• Use a damp cloth or sponge to clean the outer surface of the lamp.
• Never use scrubbing brushes, abrasive products or aggressive detergents such as acetone or spirit to clean the device.
Storage:
• Store your unit in a safe, dry place out of the reach of children.
REPLACING THE TUBE
Apart from the tube, the device does not contain any other part that needs to be replaced. The tube has a service life of approximately 8,000 hours (corresponding to several
years of normal use). The tube must be replaced with a similar tube.
To replace the tube, please follow the instructions below:
- Using a screwdriver (not supplied), unscrew the screw on the product’s base and then remove the reflector cover as shown on the diagram (Fig. 2.)
- Then unscrew the tube as shown on the diagram (Fig. 3).
- Once the tube has been replaced, replace the reflector cover and the screw before using the Lumi Lamp again.
EN
