EN
6. Cleaning objects:
a.
General cleaning
: Use clean water for general cleaning. The object should be immersed in the water, but make
sure the level does not rise above the “MAX” marking.
b.
Enhanced cleaning
: Add between 5 and 10 ml of mild detergent to the water if the object is stained or has not
been cleaned for a long time. The addition of mild detergent accelerates the decomposition of any soiling and
improves the cleaning results. At the end of the cleaning cycle, rinse the tank to remove all traces of detergent.
c.
Partial cleaning
: Partial cleaning for large objects.
d.
Thorough cleaning
: If the object needs to be cleaned thoroughly or sterilised, first use the “Enhanced cleaning”
function, then change the water and add approx. 5 to 10 ml of sterilising fluid to the tank. Restart the unit and set
the operating cycle to 90s. At the end of this cycle, the object can be cleaned thoroughly.
Repeated cycles may improve the efficiency of the cleaning. We recommend cleaning intervals of 3 minutes.
7. When the unit displays “000”, it stops automatically and the red warning light goes out. If you want to interrupt the
cleaning cycle, just press the “OFF” button. If you press the “ON” button again, the unit will resume the program and
complete the cleaning. Alternatively, you can press the “SET” button to restart the cycle.
8. At the end of the cleaning cycle, unplug the unit, open the lid and remove the object. To finish, empty the water from
the stainless-steel tank and dry it.
9. Using the optional accessories:
e. Plastic basket
Place the small objects to be cleaned in the plastic basket and immerse it in the tank. This makes it possible to
reduce friction between the objects to be cleaned and the surfaces of the tank.
Caution: the plastic basket should be used only when cleaning small objects, because it absorbs
ultrasonic energy and therefore reduces the cleaning efficiency. When using the plastic basket,
please refer to the instructions for “Enhanced cleaning” in this manual.
f. Watch holder
The ultrasonic frequency is highly penetrating. Do not place watches (unless waterproof to a depth of at least 30
metres) directly in the tank, because the water might penetrate into the mechanism and damage it.
Fit the watch to the watch holder and immerse the bracelet in the water. Like the plastic basket, the watch holder
also absorbs ultrasonic energy. When using the watch holder, please refer to the instructions for “Enhanced cleaning”.
MAINTENANCE
Unplug and empty the unit after use.
Do not leave water in the tank for long periods.
Dry the tank and the unit with a dry towel.
To reduce the risk of electrocution, do not wash the unit.
Store the unit in a cool, dry place out of the reach of children.
TECHNICAL CHARACTERISTICS
Voltage
220-240 V
Frequency
50Hz
Power consumption
50W
Ultrasonic Cleaner
5
