Bullet Tower
24VAC / 50Hz
www.lancerbeverage.com
Page 10 of 34
Hoshizaki Lancer reserve the right to change specifications without notice.
Part No: 68000028
Images are for illustration purposes only as product may vary.
No 061-2 - 17 December 2019
Adjusting Soda/Water to Syrup Brix (Ratio)
•
Obtain a Lancer brix cup with the desired
brix ratio for the syrup connected to the
valve.
•
Hold the Lancer brix cup under the
separator and activate the valve.
•
Check brix ratio, the soda/water and
syrup dispensed into the brix cup should
be level.
•
To obtain the correct brix ratio, use a
screwdriver to adjust the syrup flow
control. Adjust clockwise to increase the
syrup flow and anti-clockwise to decrease
the syrup flow.
•
Once the correct soda/water to syrup brix
ratio is obtained, repeat the measurement to verify.
•
Remove the syrup separator and install the diffuser and nozzle.
•
Slide down I.D. panel.
3.9 LEV Portion Control Programming Procedures
L
ancer
E
lectric
V
alve
The portion control has 5 actuators (selections):
small; medium; large; extra-large; pour/cancel.
When you touch a selection, the conductivity of your
finger completes an electrical circuit activating the
valve.
The control also has a lock out feature that
deactivates the selection when a button is activated
continuously for 15 or more seconds. When
powered up, the control performs a self-test by
checking each selection to ensure that a button is
not activated. If a button is activated the control
locks out that selection.
The Portion Control has 3 automated features: a 4
second timer for setting flow rate, no top off pour
and top off pour.
Four Seconds Pour Timer:
•
Place ratio cup under nozzle.
•
Touch medium and large cup size at the same time (for 1 second, light
blinks) the valve will pour for 4 seconds.
