Bullet Tower
24VAC / 50Hz
www.lancerbeverage.com
Page 6 of 34
Hoshizaki Lancer reserve the right to change specifications without notice.
Part No: 68000028
Images are for illustration purposes only as product may vary.
No 061-2 - 17 December 2019
Carefully unpack the Bullet Tower from the shipping carton. Inspect unit for concealed
damage and if evident, notify delivering carrier and file a claim against the carrier.
3.2 Selecting a Counter Location
Warning
The Tower is intended for indoor operation only; do not
operate outside unless suitably protected by a weatherproof
enclosure. This appliance is not suitable for installation in an
area where a water jet could be used.
The Tower must not be cleaned by a water jet.
Caution
The Tower is not suitable for use in subfreezing temperatures.
To prevent damage to the water supply line, turn off the unit
when air temperature is below zero.
Select a suitable firm, level, horizontal countertop location close to a properly grounded
(earthed) electrical outlet. The location should make full use of the merchandising features of
the tower to create maximum impact.
3.3 Drip Tray Installation
•
This dispenser is designed to be mounted on a Drip tray on top of a counter or bar.
•
Inspect the counter location where the unit is to be installed. Verify the selected counter is
strong enough to safely support the weight of the installed unit, after the cut-out for the unit
is made.
•
Install the drip tray as per the instruction provided with the drip tray.
3.4 Tower Installation
•
Use the mounting dimensions provided to verify the selected location; then mark the trunk
hole and four mounting holes, illuminated towers require a 15mm Ø hole for LED lead.
•
Cut the trunk hole 65mm Ø and drill four 8mm Ø mounting holes, and for Illuminated
towers a 15mm Ø hole for LED lead.
•
Holding the tower over the mounting location, feed the power wire and tubing leads
through the hole, ensuring the gasket is under the base of the tower.
•
IMPORTANT – for illuminated towers ensure that the LED lead is inserted into the 15mm
Ø hole. Seal the lead in the hole with silicon.
•
Fasten the tower using the appropriate screws, nuts and washers supplied with the Tower.
•
Installation should only be performed by a qualified and competent technician.
