10
1. Set shipping carton upright on the floor, then, cut package
banding straps and remove.
2. Open top of carton and remove interior packaging.
3. Lift carton up and off of the unit.
4. Remove accessory kit and loose parts from ice compart-
ment.
5. Clean ice bin using cleaning solution on Cleaning and Sani-
tizing Solutions section.
If unit is to be transported, it is advisable to leave the
unit secured to the plywood shipping base.
NOTE
The dispenser should only be installed in a location
where it can be overseen by trained personnel, and it
should never be installed in an area where a waterjet
can be used.
NOTE
To avoid personal injury or damage, do not attempt to
lift a unit without help. For heavier units, use of a
mechanical lift may be appropriate. Unplug dispenser
from the power source when unit is being serviced,
cleaned, or sanitized.
!
WARNING
1. Select a leveled, well ventilated location that is in close
proximity to a properly grounded electrical outlet, within
five (5) feet (1.5 m) of a drain, a water supply that meets
the requirements shown in the Specifications section found
on pages 4-7, and away from direct sunlight or overhead
lighting.
2. The selected location should be able to support the weight
of the dispenser and ice after the counter cutout is made.
Total weight (with ice) for this unit could exceed 400 pounds
(181.4 kg).
3. If installed directly on the counter, unit must be sealed to the
countertop with an FDA approved sealant.
4. If installed using the free-standing conversion kit (Lancer
PN: 84-1004/01 for 2200, 84-1005/01 for 2300, and 84-
1006/01 for 23300), unit must use the legs provided.
5. Select a location for the remote carbonator, syrup pumps,
CO
2
tank, syrup containers, and water filter (recommended).
See General System Overview on pages 8-9 for reference.
NSF listed units must be sealed to the counter or have
six (6) inch legs installed.
NOTE
INSTALLATION
Read This Manual
This manual was developed by Lancer Worldwide as a reference guide for the owner/operator and installer of this dispenser. Please read
this manual before installation and operation of this dispenser. Please see Troubleshooting section for service assistance. If the service
cannot be corrected please call your Service Agent or Lancer Customer Service. Always have your model and serial number available
when you call.
Unpacking the Dispenser
Selecting/Preparing a Counter Location
Never energize the machine if there is any trace of
damage. Contact Lancer Customer Service for
assistance.
!
WARNING
