BEV85 Annual Operational Service
Work Instruction
www.lancerbeverage.com
Page 2 of 4
Images are for illustration purposes only as product may vary.
No 074
– 1 November 2018
5
Remove Regulator Filter
Bowl
Turn Clockwise and pull down
to remove.
Clean with warm soapy water.
Take a photo or placement
and orientation
Remove Regulator Brass
Filter
Turn the Brass Cartridge
Clockwise to loosen and
remove.
Clean with warm soapy water.
Clean by placing in sanitiser
alcohol to soak and shake.
Refit by turning anti-clockwise
once cleaned or replaced.
Replace Regulator Filter
Bowl
Push up and turn anti-
clockwise to replace bowl.
6
Access Air filters (2 of)
Twist anti-clockwise and pull
on the filter casing cap to
expose the filter element
inside.
Clean air filter housings
Wipe clean the filter housing
and cap.
Replace air filter & Cap
Fit two new air filter elements,
as available in annual service
kit.
Locate filter cap onto the
housing and twist clockwise to
replace and lock into place.
7
Replace the Non-Return
Valve (NRV) Seal & Spring
With the use of a Spanner,
turn the nut anti-clockwise to
loosen.
Remove and dispose of the
spring & seal.
Note orientation of parts as
removing them.
Fit the new Seal & Spring, as
available in the annual service
kit, and replace the NRV nut.
Tighten using only fingers, in
a Clockwise direction.
8
Remove compressor head
Heat Covers
Remove the 4 fixing screws
securing the 2 heat covers.
PH2 Phillips heads.
