background image

“Lancer” is the registered trademark of Lancer © 2016 by Lancer, all rights reserved.

Lancer Corporation
6655 Lancer Blvd.
San Antonio, Texas 78219
800-729-1500

Technical Support/Warranty

800-729-1550

custserv@lancercorp.com

lancercorp.com

PN: 28-0979

Pre-Mix Cooler

Installation & Operation Manual

ABOUT THIS MANUAL

This booklet is an integral and essential part of the product and 

should be handed over to the operator after the installation and 

preserved for any further consultation that may be necessary. 

Please read carefully the guidelines and warnings contained 

herein as they are intended to provide the user with essential 

information for the continued safe use and maintenance of the 

product. In addition, it provides 

GUIDANCE ONLY

 to the user on 

the correct services and site location of the unit.

BEFORE GETTING STARTED

Each unit is tested under operating conditions and is thoroughly 

inspected before shipment. At the time of shipment, the carrier 

accepts responsibility for the unit. Upon receiving the unit,

carefully inspect the carton for visible damage. If damage exists, 

have the carrier note the damage on the freight bill and file a 

claim with carrier. Responsibility for damage to the dispenser lies 

with the carrier.

The installation and relocation, if necessary, of this product must be carried out by qualified personnel with 

up-to-date safety and hygiene knowledge and practical experience, in accordance with current regulations.

Please refer to the Lancer Corp website (lancercorp.com) for information relating to Lancer Installation/Operation 

Manuals, Installation Guides, Instruction Sheets, and Technical Bulletins or for your convenience, scan this QR code 

with a mobile device (app required) for immediate access to other Technical Documents and alternative translations 

(if available) pertaining to this unit. 

Summary of Contents for Pre-Mix Cooler









Reviews: