lancer Twin Pour, Operation Manual

14

A

B

C

D

Increase

Decrease

A. Flow Control

B. Valve Retainer 

C. Solenoid

D. Valve Body

Calibrating Brand Syrup Modules

1.  From the Service menu, press the 

Maintenance

 button.

2.  Remove the two thumb screws connecting the plastic screen 

housing to the unit (See page 9).

3.  While holding the plastic screen housing, tilt the housing 

forward until the housing disengages from the unit (See 

page 9). 

4.  While holding the screen housing, press the 

Calibrate

 tab on 

the far left side of the screen and press the 

Calibrate

 button 

for the first brand syrup module.

5.  Set the Timer to the ON position and select seconds (s) as 

the desired unit of measurement.

7.  With the graduated cylinder placed in a position below the 

nozzle, press the 

Start Dispense

 button. The unit will  

dispense the designated syrup for 4 seconds. 

8.  Examine  the  dispensed  volume  in  the  graduated  cylinder.             

If the dispensed volume does not match the value of 1.00 

oz, use a screwdriver to adjust the brand syrup flow control. 

(See Plumbing Diagram on page 17 for reference). 

The water flow rate should be set from the calibration 

of the carbonated/plain water modules in the previous 

section and the ratio should be determined from when 

the brand was configured. (See page 12, Adding New 

Brand/Flavor Module)

NOTE

The finished drink flow rate was set to 1.5 oz/sec, which 

makes the finished syrup flow rate 0.25 oz/s. In 4  

seconds, the volume of syrup that should be dispensed 

is 1.00 oz. 

NOTE

12.  To re-attach the screen housing, first align the screen 

housing with the connection tabs on the unit, then rotate the 

housing down until the connection tabs engage.

13.  Re-connect the two thumb screws removed in Step 2.
14.  Repeat steps 1 -13 for the second screen.

Make sure both of the connection tabs are disengaged 

in the open position before attempting to re-connect 

the screen housing. Use a screw driver to open the 

connection tabs if necessary.

NOTE

A

A

A. Clip in Open Position

Ensure there is ice on the cold plate and the lines are 

cold before attempting to set the flow rates on the 

valves. The drink temperature should be no higher  

than 40°F (4.4°C) when flow rates are set. 

NOTE

6.  Using the keypad, enter in a time of 4 seconds as the preset 

dispensing time.