lancer Twin Pour, Operation Manual

15

9.  Repeat steps 7 and 8 until the designated volume of 1.00 

ounce is achieved.

10.  Repeat steps 4 - 9 for the remaining brand syrup modules.
11.  To re-attach the screen housing, first align the screen 

housing with the connection tabs on the unit, then rotate the 

housing down until the connection tabs engage.

Calibrating Ambient Flavor Modules

1.  Access the Service menu (See page 7) and press the  

Maintenance

 button.

2.  Remove the two thumb screws connecting the plastic screen 

housing to the unit (See page 9).

3.  While holding the plastic screen housing, tilt the housing 

forward until the housing disengages from the unit (See 

page 9). 

4.  While holding the screen housing, press the 

Calibrate

 tab on 

the far left side of the screen and press the 

Calibrate

 button 

for any designated flavor module.

8.  With the graduated cylinder placed in a position below the 

nozzle, press the Start Purge button. The unit will dispense 

the volume designated in the previous step. 

9.  Examine the dispensed volume in the graduated cylinder. If 

the dispensed volume does not match the value entered on 

the screen in step 7, use a screwdriver to adjust the  

carbonated water flow control. (See Plumbing Diagram on 

page 17 for reference). 

A

B

C

D

Increase

Decrease

A. Flow Control

B. Valve Retainer 

C. Solenoid

D. Valve Body

10.  Repeat steps 8 and 9 if any more bonus flavor flow  

adjustment is necessary.

11.  Repeat steps 4 - 10 for any remaining bonus flavor module.
12.  To re-attach the screen housing, first align the screen 

housing with the connection tabs on the unit, then rotate the 

housing down until the connection tabs engage.

7.  Using the keypad, enter a specific volume to be dispensed 

based on the size of the graduated cylinder being used to 

calibrate the flavor module.  

5.  Using the keypad, enter a flow rate value of 0.062 oz/sec. 
6.  Set the Timer to the ON position and select ounces (oz) as 

the desired unit of measurement.

The larger the volume dispensed, the more accurate 

the results.

NOTE

12.  Re-connect the two thumb screws removed in Step 2.
13.  Repeat steps 1 -12 for the second screen.

Make sure both of the connection tabs are disengaged 

in the open position before attempting to re-connect 

the screen housing. Use a screw driver to open the 

connection tabs if necessary.

NOTE

Make sure both of the connection tabs are disengaged 

in the open position before attempting to re-connect 

the screen housing. Use a screw driver to open the 

connection tabs if necessary.

NOTE

13.  Re-connect the two thumb screws removed in Step 2.
14.  Repeat steps 1 -13 for the second screen.