18
Update Software
4. In the “Update from USB” section, press the
Software
button.
The screen will automatically conduct a power cycle
once the update is complete. Wait at least ten (10)
seconds before accessing the Service Menu once the
power cycle is complete.
NOTE
5. Verify that the correct update is displayed on the screen then
press
Start Update
.
1. Load the
.update
file on to any blank USB as shown in the
image below.
2. Plug the USB into the port on the side of the PCB controller
box, located in the upper left corner of the front of the unit.
A. USB Port
A
3. Access the Service menu on the left side screen and press
the
Data Management
button.
6. Repeat Steps 2 - 5 for the right side PCB and screen.
