22
Cleaning and Sanitizing Ice Bin, Auger, and Ice Chute
1. Disconnect power to the dispenser
2. Remove the Merchandiser and Top Cover.
3. Remove Ice Chute Lever, then remove Splash Plate
Assembly by lifting it up and out from the dispenser face.
Refer to the Automatic Agitation Warning on page 3.
NOTE
It is recommended to perform this procedure monthly,
or more often if desired. Use the cleaning solution
described above. An alternate solution of one part
water to one part vinegar may be used to remove water
spots and calcium deposits.
NOTE
Always remove the ice chute lever before removing the
splash plate.
NOTE
4. Remove or melt out any remaining ice from the ice bin.
5. Disconnect the lower, horizontal LED light bar and remove
from unit.
6. Disconnect the two vertical LED light bars on either side and
remove from unit. See
LED Lighting Configuration
diagram
on page 33 for reference.
7. Use a screwdriver to remove the Auger Motor shaft cover.
8. Remove the “C” clip from the Auger Motor Shaft.
9. Disconnect the Auger Motor wire harness from junction box.
A
B
C
A. Auger Motor Shaft
B. “C” Clip
C. Ice Chute
11. Slide the Motor and Mounting Plate Assembly off of the
Auger Shaft.
A
B
A. Auger Motor
B. Remove Screws
C
A
B
A. Auger Motor
B. Auger Shaft
C. Solenoid
12. Remove the Auger Motor Shaft Key and set aside.
13. Remove the second clip from the Auger Shaft.
14. Disconnect the Ice Chute wire harness from the junction box.
15. Disconnect the solenoid from Ice Chute link by pushing pin
through shaft until link is free. (Pin shown in out position)
16. Remove the Ice Chute Assembly by removing four (4)
screws that secure to unit and set aside.
C
A
B
A. Solenoid
B. Solenoid Pin
C. Ice Chute Link
10. Remove the four (4) screws from the bracket holding the
Auger Motor, flavor injector bracket, and LED light bracket.
