lancer Twin Pour, Operation Manual

9

See Plumbing Diagrams on the front of the unit or on 

page 31 for reference.

NOTE

1.  Connect appropriate tubing to the carbonated water outlet on 

the right side of the unit and route to the carbonated water 

inlet on the remote dispenser.

Connecting to Remote Dispenser (if necessary)

2.  Connect appropriate tubing to the plain water outlet on the 

right side of the unit and route to the plain water inlet on the 

remote dispenser.

Installing CO

2

 Supply

Before installing regulator, assure that a seal (washer 

or o-ring) is present in regulator attachment nut.

! 

ATTENTION

1.  Connect high pressure CO

2

 regulator assembly to CO

2

cylinder or bulk system.

- 

Thread regulator nut on to tank, then 

tighten nut with wrench

A. CO

2

 Regulator

B. Outlet

C. Wrench

D. CO

2 

Supply

A

B

C

D

2.  Connect a 3/8” nut, stem and seal to CO

2

 regulator outlet.

A. CO

2

 Regulator

B. Wrench

C. 3/8” nut, Stem

D. CO

2 

Supply

A

B

C

D

3.  Route appropriate tubing from the low pressure CO

2

regulator manifold location to the 3/8” nut, stem on the high 

pressure CO

2

 regulator attached to source and connect 

tubing.

A dedicated CO

2

 regulator is required to supply the CO

2

inlet at the unit as well as to all syrup pumps. 

! 

ATTENTION

This unit has the ability to supply a remote dispenser 

with chilled water and carbonated water lines. Please 

see the manufacturer’s specifications and instructions 

for installation of the remote dispenser.  The following 

are the instructions for plumbing the water lines to the 

remote dispenser. 

NOTE

Water lines feeding the remote dispenser must be  

insulated.

NOTE

A

B

C

D

A. Line to Dispenser

B. Line to Syrup Pumps

C. Line to CO

2

 Regulator

D. CO

2

 Regulator Manifold

4.  Connect tubing routed from the CO

2

 inlet at the unit to one of 

the low pressure CO

2

 regulator manifold outlets.

5.  Connect tubing routed from the tee at the syrup pumps to the 

second low pressure regulator. 

7.  Repeat Step 6 for both low pressure CO

2

 regulators on the 

regulator manifold routed to the unit and the syrup pumps.   

DO NOT TURN ON CO

2

 SUPPLY AT THIS TIME

! 

WARNING

6.  Using a wrench, loosen lock nut on the regulator adjustment 

screw of the high pressure CO

2

 regulator connected to the 

source, then using a screwdriver back out lock nut screw all 

the way.

A. CO

2

 Regulator

B. Screwdriver

C. Regulator Adjustment Screw

A

B

C