7
Dispenser Setup
1. Turn on water source.
2. Open the pressure relief valve located on the front of the
unit, by flipping up on the valve cap lever. Hold open until
water flows from the relief valve then close (flip down) the
relief valve.
The dispenser must be properly electrically grounded
to avoid serious injury or fatal electrical shock. The
power cord has a three-prong grounded plug. If a
three-hole grounded electrical outlet is not available,
use an approved method to ground the unit. Follow
all local electrical codes when making connections.
Each dispenser must have a separate electrical circuit.
Do not use extension cords. Do not connect multiple
electrical devices on the same outlet.
F
WARNING
3.
Verify all Bag-In-Box contains syrup and check all
connections for leaks.
4.
Place enough ice in the ice bin to fill approximately 1/2 of the
bin before plugging in the unit.
5. Connect unit power cord to grounded electrical outlet.
7. Test the motor operation by pushing both ice chute levers
until agitator motor begins to turn.
8. If necessary, turn on the left and right screen by pressing
the screen on/off toggle buttons on the left side of the unit
electrical box.
The manager’s access to the service menu allows
access to the Lighting screen (see page 12), the Sold
Out screen (See page 13), and the Time & Delays
screen (See page 12).
NOTE
14.
For access to only the Sold Out Menu, repeat steps 10 - 11
and enter the Sold Out pin
(963.)
.
15. From the service menu press the
Maintenance
button.
11.
After you have held your finger for a minimum of four (4)
seconds, tap all four corners of the screen in any order.
12. A keypad will appear, enter the designated pin number to
access the service menu.
13.
For manager’s access to the service menu, repeat steps 10 -
11 and enter the manager’s pin number
(6655)
.
6.
Turn on the power to the dispenser by pressing the on/off
toggle button on the right side of the unit electrical box.
9. Once the screen has booted up, access the service menu by
placing your finger at the right side edge of the screen.
10.
In one swift, fluid motion slide your finger along the center
of the screen to the left till you reach the left edge of the
screen, then hold your finger to the screen for a minimum of
four (4) seconds.
C
A
B
D
A. Pressure Relief
Valve
B. CO2 Inlet
C. Plain Water Out
D. Carb Water Out
A
A. Dispenser Power
On/Off
