Lancol
MICRO-768 Battery Tester User Manual
8
Press the reset key of the current clamp and connect the current clamp jaw to the anode
wiring between the battery to be tested and the generator. See below picture.
As the minimum width of the current clamp jaw is only 28mm, choose the connection
cable or connection pole with diameter less than 28mm to test. Otherwise, the current
clamp jaw cannot close completely.
NOTE: 1. Current clamp jaw must close to avoid test tolerance.
2. Current clamp uses 9V alkaline battery. Turn the clamp power off after
using the current clamp.
3. Before testing the current, take off the current clamp from the battery
positive connection cable, and reset.
3.2 Tester Startup
Tester will start up after pressing the power key, and display the customized
logo interface (Default voltmeter is ON) refer to figure 1.
Figure 1, Startup Interface with Voltmeter On
