LANCOM 821+ – LANCOM 1711+ VPN – LANCOM 1721 VPN
Chapter 6: Providing dial- in access
55
EN
Print out profile
Sending a profile via e-mail could be a security risk should the e-mail
be intercepted en route!
To send the profile via e-mail, the device configuration must be set up
with an SMTP account with the necessary access data. Further, the
configuration computer requires an e-mail program that is set up as
the standard e-mail application and that can be used by other appli-
cations to send e-mails.
When setting up the VPN access, certain settings are made to optimize oper-
ations with the LANCOM Advanced VPN Client, including:
Gateway: If defined in the LANCOM VPN Router, a DynDNS name is used
here, or alternatively the IP address
FQDN: Combination of the name of the connection, a sequential number
and the internal domain in the LANCOM VPN Router.
Domain: If defined in the LANCOM VPN Router, the internal domain is
used here, or alternatively a a DynDNS name or IP address
VPN IP networks: All IP networks defined in the device as type 'Intranet'.
Preshared key: Randomly generated key 16 ASCII characters long.
Connection medium: The LAN is used to establish connections.
VoIP prioritization: VoIP prioritization is activated as standard.
Exchange mode: The exchange mode to be used is 'Aggressive Mode'.
IKE config mode: The IKE config mode is activated, the IP address infor-
mation for the LANCOM Advanced VPN Client is automatically assigned
by the LANCOM VPN Router.
6.5
Instructions for WEBconfig
RAS access via VPN cannot be configured using the wizard under
WEBconfig yet. It can only be set up in the expert configuration. For
details, please refer to the reference manual.
From the main menu, launch the 'Connect two local networks' wizard.
Follow the wizard's instructions and enter the required information.
Configure Dial-Up Networking access on the dial-in PC as described.
Next, test the connection (see box ’Ping – quick testing for TCP/IP connec-
tions’).
