LANCOM Wireless DSL – LANCOM Wireless ADSL
Chapter 2: Installation
30
EN
Note that resetting the device leads to a loss on the WLAN encryption
settings within the device and that the default WEP key is active again
(’Standard WEP encryption’
2.4
Hardware installation
The installation of the LANCOM Wireless DSL base station takes place in the
following steps:
햲
Antennas
– Screw on the both included diversity antennas at the back of
the LANCOM Wireless DSL base station.
햳
LAN
– First connect the LANCOM Wireless DSL base station to your LAN
or to an individual PC. For that purpose, plug the included network cable
(green plugs) into the LAN connector of the device
쐋
and the other end
into a free network connecting socket of your local network, into a free
socket of a hub/switch or into the network socket of an individual PC.
The LAN connector identifies automatically the transfer rate (10/100
Mbps) of the connected network device (autosensing). A parallel connec-
tion of devices with different speeds and types is possible.
You should never have more than one unconfigured LANCOM
Wireless DSL in a network segment at any given time. All unconfig-
ured LANCOM Wireless DSL devices use the same IP address (with the
final digits '254'), which would result in an address conflict. To avoid
problems, always configure multiple LANCOM Wireless DSL devices
one at a time, immediately assigning each device a unique IP address
(one that does not end with '254').
1511/1811 only
햴
DSL
– connect the WAN interface
쐏
to the DSL modem socket using the
supplied DSL connector cable (dark blue plugs).
1521/1821 only
햵
ADSL
– connect the ADSL interface
쐏
to the splitter using the supplied
ADSL connector cable (transparent plugs).
햶
ISDN
– to connect the LANCOM Wireless DSL to the ISDN, plug one end
of the supplied ISDN connector cable (light blue plugs) in the ISDN/S
0
port
쐄
of the router and the other end into an ISDN/S
0
multi-device mode or
point-to-point mode connection.
