LANCOM OAP
-
54
-
1 Wireless – LANCOM OAC
-
54
-
1 Wireless
Chapter 2: Installation
23
EN
More information about using a LAN interface for DSLoL can be found in
the following information box
→
’LAN interface: exclusive or in parallel
for DSLoL.
햶
PoE—the 'LAN In' connector of the supplied PoE Injector should be con-
nected via a normal Ethernet cable to an available network connection
socket in your local network (e.g. an available socket on a hub or switch)
and the PoE Injector connected with the electricity supply.
Information about the installation of PoE can be found in the information
box 'Power over Ethernet—elegant power supply over LAN cabling'
above.
Please observe the information in the documentation supplied with the
PoE Injector.
Use only the supplied PoE Injector for the power supply of the
LANCOM OAP/OAC-54-1 Wireless. Pay particular care not to connect
the PoE Injector to normal Ethernet devices!
햷
Ready for operation? —the Power LED permanently lights up in green as
soon as the device receives power. The LEDs subsequently display the
operational status.
LAN interface: exclusive or in parallel for DSLoL
There are two principle DSLoL operation modes available. Either use the exclusive mode when
connecting your LANCOM Access Point directly to a DSL modem, or use the automatic mode
when connecting the Access Point to a hub or switch of a cable-bound LAN, and connect this
hub/switch again to the DSL modem. If
the Access Point is broadcasted as gate-
way via DHCP, computers in LAN and
WLAN can use the internet connection
simultaneously
via one physical inter-
face. Set the desired mode in LANconfig
in the Interface settings of the DSLoL
interface.
DSLoL supports all PPPoE-based Internet access lines, as well as those that are sup-
plied with a access router with multiple fixed IP addresses (such as many SDSL busi-
ness lines).
