2
Third Function Valve Kit #380-152A Installation Instructions 380-153M
10/05/15
Land Pride
Assembly Instructions
■
Control Lever Assembly
Refer to Figure 2 on page 1 & Figure 3:
1.
Remove existing knob (not shown) from end of
control lever “C”.
2.
Install new joystick (#14) over end of control lever “C”
with push buttons facing operator as shown.
3.
Tighten set screws (#4) against control lever “C”.
Tighten jam nuts (#5) to secure set screws (#4).
Refer to Figure 2 on page 1:
4.
Reference Connection “B”:
Connect the two red
wires from the joystick (#14) to one end of wire (#8)
with fuse holder (#16), and connect opposite end of
wire (#8) to the positive (+) post on the tractor battery.
5.
Reference Connections “A”:
Connect the two black
wires from joystick (#14) to the two wires from the
third function valve (#10).
Refer to Figure 3:
6.
Secure wiring with cable ties (#3) as needed.
Cross Beam Mount Assembly
Refer to Figure 2 on page 1 & Figure 4:
1.
Orient bulk head mount (#1) as shown and attach it to
the right-hand side of loader crossbeam “D” with
u-bolt (#7) and hex whiz nuts (#6). Tighten hex whiz
nuts to the proper torque.
Refer to Figure 2 on page 1, Figure 4, & Figure 5:
2.
Route hydraulic hoses (#9) along the loader arm and
through loader loop bracket “E” to the third function
valve assembly (#10).
3.
Connect hoses to quick couplers (#11) on
“A” & “B” ports of valve block (#10).
4.
Secure hydraulic hoses (#9) as needed with
cable ties (#3).
Corporate Office: P.O. Box 5060
Salina, Kansas 67402-5060 USA
www.landpride.com‘
Figure 3
Figure 4
Figure 5
37119
Push Buttons
15
4
14
C
3
5
37120
1
9
6
7
D
37121
9
E
