Section 1: Options & Accessory Set-up
SPL0548 & SPL0560 Snow Pusher 303-454M
11/9/20
17
Unhook BX Loader Direct Pin
Refer to Figure 1-9 on page 16:
WARNING
!
To avoid serious injury or death: The Snow Pusher is back
heavy and can tip over backwards easily once unhooked.
Always unhook unit on level ground with support blocks under
the skid shoes at the back to tip the unit forward. Never unhook
unit with back of unit facing downhill.
on page 25 when parking
attachment for long periods or at the end of the
working season.
2. Reduce tractor engine speed to an idle and park
tractor and Snow Pusher on level, solid ground.
3. Lower Snow Pusher until back of skid shoes are
resting on support blocks (#6) and front of skid shoes
are resting on the ground.
4. Shut tractor down properly. Refer to
5. Pull hairpin cotters (#5) and remove lower hitch
pins (#1) from the Snow Pusher.
6. Remove nut (#4), bolt (#3), and hitch pin (#2).
7.
Restart tractor and back away from the Snow Pusher.
8. Shut tractor down properly before dismounting.
9. Replace hitch pins (#1 & #2) in the Snow Pusher
clevises.
10. Secure lower hitch pins (#1) with hairpin cotters (#5).
11. Secure center hitch pin (#2) with bolt (#3) and lock
nut (#4). Screw-on lock nut only 3 or 4 full turns.
