Section 3: Operating Instructions
11/7/18
FDR3690 Rear Discharge Grooming Mower 310-447M
19
General Operating Instructions
By now you should have thoroughly read your Grooming
Mower Operator’s Manual, properly attached your Land
Pride FDR3690 to your tractor, and reviewed the
operating checklist. You should have also inspected the
area where you intend to mow and cleared it of safety
hazards and foreign objects. If you have not yet
completed all of these functions, it is an absolute must
that you do so now before proceeding.
Now that you are properly briefed and prepared, its time
to start the tractor and move to your starting point. When
transporting to your mowing site, select a safe ground
transport speed. When traveling on roadways, transport
in such a manner that faster moving vehicles can easily
see you and pass you safely. When travelling over rough
and hilly terrain, reduce your speed and avoid quick or
sharp steering corrections. Take extra care to ensure that
the mower doesn’t come into contact with obstacles such
as trees, buildings, or fences.
When you have arrived at the mowing site, start the
tractor, raise the deck to make sure that everything is
properly attached and that the driveline is not in a bind or
in contact with the mounting frame. Also make sure the
tractor tires aren’t in contact with the deck. With the deck
still in the raised position, proceed to your starting point
and lower your deck to the ground in mowing position.
Reduce your tractor engine rpm to idle and engage
power take-off. Gradually raise tractor engine rpm to
achieve the
540-rpm power take-off speed. Now begin mowing at a
ground speed of approximately 4-5 mph.
The proper mowing speed will ultimately be determined
by ground conditions, desired finish, common sense, and
good safe mowing practices by the operator.
Grass is best cut when it is dry. Mowing in wet grass can
cause plugging resulting in grass clumps behind the
mower. Grass should be mowed frequently as shorter
clippings deteriorate faster. When mowing in tall grass it
is best to raise the cutting height, mow the area, then
lower the cutting height, and mow a second time.
After mowing approximately 50 ft., stop the tractor,
disengage the power take-off, set the brake, turn off the
engine, remove the key, and dismount the tractor to see if
the mower is adjusted properly. If you need to dismount
the tractor on a hill or incline to inspect, adjust, or park the
mower for any reason, place wheel chocks under the rear
tires for added safety. Once you have made necessary
adjustments, you may continue mowing. Do not engage
the power take-off at high engine rpm and avoid making
sharp turns if at all possible. If anyone approaches while
you are mowing, disengage the power take-off and stop
the tractor.
With a little practice and experience you will become very
good at operating your Land Pride FDR3690 Rear
Discharge Grooming Mower. Always remember that
there is no substitute for proper maintenance and good
safe operating practices. See
“Features and Benefits”
section or
“Product Specifications”
for additional
information and performance enhancing options.
