1
© Copyright 2005
Printed
Before You Start
Your Land Pride Electric Actuator is exclusively
designed for your Land Pride FPS48 Food Plot Seeder.
Please read these installation instructions and the Food
Plot Seeder Operator’s Manual thoroughly before
beginning. Especially read information relating to safety
concerns. Also included in the Operator’s Manual is
important information on operation, adjustment,
troubleshooting, and maintenance for this attachment
(some manual sections do not apply to all accessories).
A separate Parts Manual for replacement parts can be
purchased from your dealer or available free of charge at
www.landpride.com. Have model and serial numbers
handy when placing an order.
Manual Part Numbers:
• Operator’s Manual . . . . . . . . . . . . . . . . . 322-118M
• Parts Manual . . . . . . . . . . . . . . . . . . . . . 322-118P
General Information
These assembly instructions apply to the following
Electric Actuator Accessories listed below:
322-119A
ELECTRIC LIFT ACTUATOR PACKAGE
Tools required:
•
Safety Glasses
•
Work Gloves
Assembly Instructions
A detailed listing of parts for the accessory kit is provided
on page 3. Use the list as a checklist to inventory parts
received. Please contact your local Land Pride dealer for
any missing hardware.
Linear Actuator
Installation
Refer to Figure 1-1:
1.
Park the Food Plot Seeder on a flat level surface.
When you see this symbol, the subsequent
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
!
IMPORTANT: Before you begin, read these
instructions and check to be sure all parts and tools
are accounted for. Please retain these installation
instructions for future reference and parts ordering
information.
2.
Adjust ratchet jack to lower the FPS48 disc gangs
onto the ground until all pressure is removed from
the clevis pins. Remove ratchet jack from the seeder.
3.
Attach lower end of linear actuator (#3) to the front
mounting lug (B) with hitch pin (#2). Secure in place
with hair pin clip (#1).
4.
Attach hand controller (#4) to the linear actuator by
plugging connector (E) into connector (F).
Linear Actuator Assembly ()
Figure 1-1
Refer to Figure 1-2 on page 2:
!
CAUTION
Make sure all electrical wiring is supported in such a way that
it will not come in contact with trash, lift mechanism, rotating
discs, pinch points, vehicle rotating components, hot exhaust
components, etc.
23907
For Model FPS48 Plot Ranger
Electric Lift Actuator
For Food Plot Seeder
4/17/06
Manual No. 322-121M
