Section 1: Assembly & Set-up
3/17/20
21
7.
Start tractor, raise implement slightly, and drive
forward enough to clear the support.
8. Lower implement to ground and shut tractor down
before dismounting. Refer to
Maximum Driveline Movement During Operation
Figure 1-14
Check Driveline Interference
Refer to Figure 1-14:
DANGER
!
To avoid serious injury or death:
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment supported
by concrete blocks or hydraulics. Concrete can break,
hydraulic lines can burst, and/or hydraulic controls can be
actuated even when power to hydraulics is off.
WARNING
!
To avoid serious injury or death:
A rotating driveline must not exceed an angle of 25 degrees up
or down, and never engage a driveline while at an angle
exceeding 25 degrees up or down. The driveline can break and
1. Raise Stump Grinder fully up.
2. Without changing 3-point lift height, shut tractor
down before dismounting. Refer to
3. Support Stump Grinder in the raised position to keep
it from falling.
4. Check to make sure the driveline does not exceed
any of the limits listed below:
•
Driveline does not exceed maximum allowable
length recorded in step 2 under
•
Driveline angle does not exceed 25
o
above
horizontal or 25
o
below horizontal.
5. If any limit was exceeded, adjust tractor 3-point lift
limiter to the height that will keep the driveline within
the recommended limit listed above. Supports
placed under the grinder may need to be lowered to
complete this step.
6. If needed, repeat steps 1-5 until all limits mentioned
in step 3 are maintained.
24872
