Section 5: Maintenance & Lubrication
10/26/17
26
Gearbox
Method 1:
With a wrench, unscrew top vented dipstick
(#1). Wipe oil from dipstick and screw dipstick in without
tightening. Unscrew dipstick and check oil on dipstick. If
below bottom level mark, add recommended gear lube
through dipstick hole until oil reaches top mark on
dipstick. Reinstall vented dipstick and tighten.
Method 2:
Remove side oil plug (#2). If oil is below
bottom of plug hole, add recommended gear lube
through top dipstick hole until oil flows out of side plug
hole. Reinstall and tighten side oil plug (#2) and vented
dipstick (#1).
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil reaches top mark on dipstick or
begins to flow out side plug hole in gearbox.
Do not overfill gearbox with oil! Oil will
expand when hot! Make sure implement is level and oil
is cool before checking oil level.
30215
Do Not Overfill
IMPORTANT:
This implement is shipped with a
NOTE:
Use a suction or siphon pump to drain
gearbox of oil when there is not an oil drain plug.
35788
35787
As
Required
Bearing in Blade Spindle Hubs
Type of Lubrication: Multi-purpose Grease
25
Hours
Wheel Support Busings & Wheel Bearings
Type of Lubrication: Multi-purpose Grease
25
Hours