Section 4: PFS8010 Assembly & Set-Up
PFS4000, PFS5060 & PFS8010 Pendulum Spreaders 309-124M
11/20/20
22
Hopper Support Ring Assembly
Refer to Figure 4-3:
1. Attach
long
support brackets (#2) with bent ends up
to the main frame rear tabs with M10 x 30 (1 3/16")
carriage bolts (#7), flat washers (#8) and hex nuts
(#9). Draw nuts up snug, do not tighten.
2. Attach hopper support ring (#1) to main frame
support saddle (#10) with M10 x 70 (2 3/4") carriage
bolts (#4). Tap bolt heads into support rings with
hammer. Secure bolts with flat washers (#5) and hex
nuts (#6). Draw nuts (#6) up snug, do not tighten.
3. Attach long support brackets (#2) to hopper support
ring (#1) with M10 x 30 (1 3/16") carriage bolts (#7),
flat washers (#8) and nuts (#9). Draw nuts up snug,
do not tighten.
4. Attach short support brackets (#3) with bent ends up
to the main frame front tabs and to hopper support
ring (#1) with M10 x 30 (1 3/16") carriage
Hopper Support Ring Assembly
Figure 4-3
30771
bolts (#7), flat washers (#8) and hex nuts (#9). Draw
nuts up snug, do not tighten.
5. Tighten nuts (#6 & #9) to the correct torque in the
following sequential order:
a. Press down on the hopper support ring at the
back to make certain the rear support brackets
are in their lowest position in the mounting slots
and tighten nuts (#9) in the bottom rear tabs.
b. Continue pressing down on the support ring at the
back and tighten nuts (#9) at the top of the rear
support brackets.
c. Tap on heads of bolts (#4) to seat them into the
support ring (#1).
d. Center bolts (#4) in the support saddle slots and
tighten middle nut (#6).
e. Tighten outside two nuts (#6).
f. Tighten nuts (#9) at the top and bottom of the front
support brackets (#3).