Section 1: Assembly & Set-up
11/29/18
PTS500 & PTS700 (Pull-Type) Broadcast Spreaders 309-125M
8
4. Attach entrainer (#5) to spreader drive shaft (#1) with
M8 x 14 (9/16") spring pin (#6). Be sure to drive
spring pin all the way in.
5. Make certain key (#7) is still in keyway of drive shaft.
6. Turn assembled support frames upright for the
remaining assembly instructions.
7.
Insert spreader disc drive shaft (#1) through pillow
block bearing (#11) and attach to gearbox output
shaft (#8) with existing M6 set screw (#9).
8. Tighten set screws (#9 & #10) to the correct torque.
Do not tighten bearing locking collar (#11) and
bearing mounting bolts (#12) at this time.
Spreader Disc Installation
Figure 1-7
Poly Hopper
Refer to Figure 1-8 on page 9:
1.
Orient poly hopper with gate openings straddling
both sides of lever mounting bracket. Land Pride
decal is on back side of hopper.
2. Attach hopper (#1) to support frame tubes with
M10 x 20 (3/4") carriage bolts (#3) and
M10 nuts (#6). Draw nuts up snug, do not tighten.
3. Attach hopper front to center 3-Point clevis with
M10 x 20 (3/4") carriage bolt (#5), M10 x 30 (1 3/16")
flat washer (#6) and nut (#7). Draw nut up snug, do
not tighten.
30667
NOTE:
Tap carriage bolts (#3 & #5) into poly
hopper before installing nuts (#4 & #7).
Wheels & Drive Shaft Bearing
1.
Attach wheels (#1) to right and left-hand axles (#2)
with TE 8 x 50 (2") cap screw (#3) & locking nut (#4).
Tighten nuts to the correct torque.
2. With locking collar facing up, attach bearing (#8) to
bracket (#5) with M10 x 30 (1 3/16") bolts, flat
washers (#7), and hex nuts (#9) in as shown. Draw
hex nuts (#9) up snug, do not tighten at this time.
Wheel & Drive Shaft Bearing Installation
Figure 1-5
Spreader Disc
1.
Insert spreader disc drive shaft (#1) into hub of end of
spreader disc (#2) until second hole from end of drive
shaft aligns with hole in hub.
2. Drive M8 x 14 (9/16") spring pin (#3) through
spreader disc hub and drive shaft.
3. Drive a second M5 x 40 (1 9/16") spring pin (#4) fully
inside the first spring pin (#3).
Spreader Disc Assembly
Figure 1-6
30663
IMPORTANT:
Install drive shaft (#1) to spreader
disc (#2) before installing drive shaft to gearbox.
30607