55
Section 5: Maintenance & Lubrication
RCF3696, RCFM3696, RCF3610, & RCFM3610 Rotary Cutters 326-600M
8/20/21
Maintenance
Proper servicing and adjustments are key to the long life
of any implement. With careful inspection and routine
maintenance, you can avoid costly downtime and repair.
Check all bolts and pins after using the cutter for several
hours and on a regular basis thereafter to ensure they are
tight and secured. Replace worn, damaged or illegible
safety labels by obtaining new labels from your Land
Pride dealer.
DANGER
!
To avoid serious injury or death:
•
Perform maintenance only on a cutter that is not running.
Disengage power take-off, place tractor in park or set park
brake, shut tractor engine off, remove switch key, and wait
for blades to come to a complete stop before dismounting
tractor to perform maintenance.
•
Always disconnect the driveline from the power take-off
shaft before servicing underside of cutter. The tractor can be
started with the power take-off engaged.
•
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment
supported by concrete blocks or hydraulics. Concrete can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
WARNING
!
To avoid serious injury or death:
•
Make sure controls are all in neutral position or park before
•
Perform scheduled maintenance. Check for loose
hardware, missing parts, broken parts, structural cracks,
and excessive wear. Make repairs before putting the
•
Do not alter implement or replace parts on the implement
with other brands. Other brands may not fit properly or
meet OEM (Original Equipment Manufacturer)
specifications. They can weaken the integrity and impair the
safety, function, performance, and life of the implement.
Replace parts only with genuine OEM parts.
•
Buildup of debris around moving components and
gearboxes is a fire hazard. Keep rotating parts and
•
Improper oil level can cause bearing failure and be a fire
hazard. Maintain proper gearbox oil level.
Hydraulic System
One of the most important things you can do to prevent
hydraulic system problems is ensure that your tractor's
reservoir remains free of dirt and contamination.
Use a clean cloth to wipe hose ends before attaching
them to your tractor. Replace your tractor’s hydraulic filter
element at the prescribed intervals. These simple
maintenances will go a long way to prevent occurrence of
control valve and hydraulic cylinder problems.
Tire Maintenance
WARNING
!
To avoid serious injury or death:
•
Tire changing can be dangerous and should be performed
by trained personnel using correct tools and equipment.
When removing and installing wheels, use wheel handling
equipment adequate for the weight involved.
•
Always release all air pressure in air-filled airplane tires
before removing hardware bolting the split rims together.
Not doing so can cause the split rims to blow apart instantly
and could result in serious injury or death.
•
When inflating tires, use a clip-on chuck and extension hose
long enough to allow you to stand to one side and NOT in
front of or over the tire assembly. Use a safety cage if
available. Do not over inflate tires.
•
Do not weld on or heat a rim. Air pressure inside the tire
can increase enough to cause an explosion. High heat can
weaken and/or warp the rim, damage the tire, and destroy
Air Filled Airplane Tires with split Rims
Figure 5-1
1. Check tires for low air pressure, missing nuts,
missing lug bolts, wear, separated rubber, and bent,
broken, or cracked wheel rims.
2. Inflate air filled tires to the proper pressure. Refer to
Refer to Figure 5-1:
3. Replace wheel rims and tires as needed with
genuine Land Pride parts. Do not loosen split rim
hardware (#1) until all air pressure in the tire has
been removed.
33925
1
Section 5:
Maintenance & Lubrication
