68
Section 7: Features & Benefits
RCF3696, RCFM3696, RCF3610, & RCFM3610 Rotary Cutters 326-600M
8/20/21
Section 7:
Features & Benefits
RCF(M)3696 & RCF(M)3610 Models
Features
Benefits
Surpassed rugged
industry standards
All Land Pride Cutters have been designed and tested and meet rigorous voluntary testing
procedures.
540 or 1000 rpm
Fits wider variety of tractors.
High gearbox hp rating
Gearboxes are built rugged. See Specifications for actual Gearbox hp ratings.
5 Yr. limited gearbox warranty
Shows our confidence in the gearbox integrity.
3 Gearboxes
Allows equal torque to be spread to left and right gearbox.
Splined rubber flex-couplers
between the center and
outboard gearboxes
Protects the driveline and gearboxes from hard objects in the blade path.
Pull-Type constant velocity
driveline Option
Constant velocity driveline reduces chatter and extends life of U-joint during turns.
Slip-clutch protection
on main driveline
Slip-clutch is more convenient than shear-bolt, protects gearbox against sudden impact.
8'- Cat. 1 & 2 or 10'- Cat. 2 & 3
3-point and semi-mount
hitches or pull-type hitch
Fits a wide range of tractors.
Semi-Mount and Pull-Type fit older tractors without a top link and smaller tractors without
enough lift capacity.
10 Gauge deck, fully welded
Fully welded deck adds rigidity.
1/4" Thick sidewalls
Protects sidewalls from thrown objects.
Round back design
Allows for cleaner and efficient discharge of material, helps eliminate damage to rear
corners by not sticking out.
Pull-Type w/dual leveling rods
Dual leveling rods eliminate deck twisting when going over uneven terrain.
Chain or rubber guard option
Reduces flying debris.
Full length skids
with replaceable shoes
Adds reinforcement to side panels. Replaceable shoes allow for change before wearing
through to weld-on piece.
Splined blade hub
Splined blade hub offers tight non-slipping attachment to output shaft.
3/16" Round stump jumper
Standard stump jumper aids in sliding over obstructions, which helps protect gearbox
output shaft.
1" x 5" Blade bar
Heavy-duty blade bar adds support to stump jumper as well as gearbox output shaft.
1/2" x 4" Heat-treated blades
Heat-treated blades last longer than non-heat-treated blades.
3" Diameter cutting capacity
Aids in cutting brush.
High blade tip speed
Means cleaner cutting. See Specifications for actual blade tip speeds.
Laminated tires
Laminated tires can handle almost any condition and don’t go flat.
Quick Hitch adaptable
3-Point and semi-mount are Quick Hitch adaptable.
