6
Manual No. 330-148M
3/11/10
Assembly Instructions
Fixed Blade Mounting Holes
Refer to Figure 6:
The bolt holes for mounting fixed blades to the wing
decks are not included on earlier models. See location of
mounting holes below to determine if your cutter has the
mounting holes. If mounting holes are present, skip to
“Center Deck Fixed Blade Assembly” on page 7. If
holes are missing, add them to the deck as follows:
1.
Locate and drill four 9/16" dia. holes on the left wing
deck as shown in Figure 1.
2.
Repeat step 1 above for the right wing deck.
Bolt Hole Pattern For Mounting Fixed Blades On The Wings (Left Wing Shown
Figure 6
30182
