Section 2: Tractor Hook-up & Unhook
SBD3596 & SBD35108 Snow Blowers 370-347M
4/9/21
18
Tractor Hook-up
Refer to Figure 2-6:
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking the
implement. Keep people and animals away while backing-up
to the implement or pulling away from the implement. Do not
operate hydraulic controls while a person or animal is directly
behind the power machine or near the implement.
The SB35 Series Snow Blowers will receive a Cat. ll or lll
3-point hitch.The lower 3-point arms must be stabilized to
prevent side-to-side movement. Most tractors have sway
blocks or adjustable chains for this purpose.
1. Adjust Snow Blower hitch for your particular 3-point
hook-up. Refer to
on page 17. Make sure
the Snow Blower hitch pin set-up is correct for your
tractor before backing tractor up to the unit.
3. Slowly back tractor to the Snow Blower while using
tractor’s 3-point hydraulic control lever to align lower
3-point hitch holes with clevis hitch pin holes.
4. Engage tractor park brake, shut tractor engine off,
and remove key before dismounting from tractor.
5. Attach lower 3-point arms to align arms with hitch
pins (#1). Secure hitch pins with linchpins (#2).
NOTE:
Land Pride’s Quick Hitch can be attached to
the tractor to provide quick and easy 3-point hook-
up and detachment. See your nearest Land Pride
dealer to purchase a Cat. ll Quick Hitch.
NOTE:
before hooking-up tractor to Snow Blower.
6. Connect top center link hitch hole to upper clevis
hitch holes with customer supplied hitch pin (#4) and
hairpin cotter (#3).
Park Stand Adjustments
Figure 2-7
Refer to Figure 2-7:
7.
Return to tractor and slowly raise Snow Blower until
park stand (#14) is off the floor 1 or 2 inches.
8. Place gear selector in park, set park brake, shut
tractor off, and remove switch key.
9. Pull wire retaining pin (#15) and raise park
stand (#14) to hole “E”. Reinsert wire retaining pin
and hook wire retainer over end of pin.
10. Slowly and carefully raise and lower Snow Blower to
ensure drawbar, tractor tires, and other equipment on
the tractor do not contact the Snow Blower. If
needed, move or remove tractor drawbar or adjust
3-point hitch on the Snow Blower.
35744
Driveline Installation (Standard 3-Point Hitch Hook-up Shown)
Figure 2-6
37321
37298
