11
Section 2: Adjustments
2/12/21
Parking Stands
Storage Position Without Added Weight
Refer to Figure 2-1:
Parking stands may be adjusted fully down so that the
Straw Crimper discs are supported above ground as
shown in Figure 2-1. Use this position only when parking
the Straw Crimper without weight added to the unit.
Storage Position With Added Weight
Refer to Figure 2-2:
If weight has been added to the unit, the parking stands
must be adjusted so that the Straw Crimper discs rest on
level ground as shown in Figure 2-2.
Working Position
Refer to Figure 2-3:
The four parking stands should be fully raised for working
and while transporting.
Parking Stand Unhooked Position without added weights
Figure 2-1
Parking Stand Unhooked Position with added weights
Figure 2-2
Parking Stands Shown in Working Position
Figure 2-3
Discs Supported
Above Ground
Extended Parking
Stand Fully Down
And Secured With
Wire Retaining Pin
19165
Discs Must Rest
On Level Ground
Parking Stand Must
Be Adjusted So
That Disc Rest On
Level Ground
19173
19169
Section 2:
Adjustments
