Installation Guide
Part F
Page 5
Installation Guide
Part F
Page 5
F5 INSTALLING MEMORY CARDS
Two memory cards can be inserted into the
FTI 6
, for storing thermal, visual
images and audio commentary. A 16Mb card has the capacity to store up to 64
thermal/visual imagers and associated audio commentary.
To insert a memory card:
1. Ensure that the imager is switched ‘OFF’, open the rear access panel on
the imager.
2. Insert the memory card into an empty slot, push in until the eject button
clicks out. The Card LED will flash to confirm installation (refer to Fig. F2).
3. Close the rear access panel.
NOTE
The memory cards can only be inserted in one position. If the card
will not insert fully DO NOT us force, as the card and imager may be
damaged.
The imager can now be switched ‘ON’.
To remove a memory card:
1. Ensure that the imager is switched ‘OFF’, open the rear access panel on
the imager.
2. Press the memory card eject button to release the card (refer to Fig. F2).
3. Remove the card and close the rear access panel.
The imager can now be switched ‘ON’.
WARNING
The rear access panel MUST be closed securely before the
FTI 6
is
used. If not the sealing integrity and electromagnetic compatibility
will be reduced.
F5 INSTALLING MEMORY CARDS
Two memory cards can be inserted into the
FTI 6
, for storing thermal, visual
images and audio commentary. A 16Mb card has the capacity to store up to 64
thermal/visual imagers and associated audio commentary.
To insert a memory card:
1. Ensure that the imager is switched ‘OFF’, open the rear access panel on
the imager.
2. Insert the memory card into an empty slot, push in until the eject button
clicks out. The Card LED will flash to confirm installation
(refer to Fig. F2)
.
3. Close the rear access panel.
NOTE
The memory cards can only be inserted in one position. If the card
will not insert fully DO NOT us force, as the card and imager may be
damaged.
The imager can now be switched ‘ON’.
To remove a memory card:
1. Ensure that the imager is switched ‘OFF’, open the rear access panel on
the imager.
2. Press the memory card eject button to release the card
(refer to Fig. F2)
.
3. Remove the card and close the rear access panel.
The imager can now be switched ‘ON’.
WARNING
The rear access panel MUST be closed securely before the
FTI 6
is
used. If not the sealing integrity and electromagnetic compatibility
will be reduced.
